3D-printing fabrication of microwave-microfluidic device for droplets network formation and characterisation

Kai Silver,Jin Li,Pantelitsa Dimitriou,Colin Kallnik,Adrian Porch,David Barrow

DOI: https://doi.org/10.1101/2024.04.08.588546

2024-04-11

Abstract:Microwave-microfluidic devices (MMDs) have emerged as precision tools for the rapid, accurate, sensitive, and non-invasive characterisation of low-volume liquids. However, the fabrication of MMDs remains a significant challenge due to the complexities associated with integrating fluidic ducts and electronic components. Herein, we present a versatile and economical 3D-printing approach for MMD fabrication, using liquid metal as an electrical conductor. Cyclic olefin copolymer, polylactic acid and polypropylene were identified as potential printable dielectric materials for MMD fabrication. 3D-printed cyclic olefin copolymer substrates exhibited the lowest loss tangent of 0.002 at 2.7GHz, making it an ideal material for high frequency engineering. Liquid metal, specifically gallium indium eutectic, was injected into the printed ducts to form conductive microwave structures. Exemplar MMDs were fabricated to integrate split-ring type microwave resonators and droplet-forming fluidic junctions. These devices were applied in the formation and characterisation of water-in-oil emulsions for constructing definable lipid-segregated droplet interface bilayer (DIB) networks. This work not only indicates the feasibility of using 3D-printing for rapid prototyping of customised MMDs but also demonstrates the potential of MMDs as a new research tool for biochemistry and synthetic biology.

Bioengineering

What problem does this paper attempt to address?

This paper primarily addresses the manufacturing challenges of microwave microfluidic devices (MMDs). Traditional manufacturing of MMDs is complex due to the integration of fluid channels and electronic components. The researchers propose an economical and flexible 3D printing method that uses liquid metal as the conductive material to fabricate MMDs. They tested different 3D printing materials such as cycloolefin copolymers, polylactic acid, and polypropylene, and found that cycloolefin copolymers exhibit low-loss characteristics in high-frequency engineering. The microwave structures are formed by injecting liquid metal gallium-indium alloy into the printed channels.

These devices combine microwave resonators and fluidic junctions for forming water-in-oil emulsion droplets to construct a well-defined bilayer lipid membrane network (DIB). MMDs not only demonstrate the capability of rapid prototyping customization using 3D printing but also show their potential in biochemical and synthetic biology research. In the paper, the authors demonstrate through experiments how to generate and characterize individual emulsions using 3D printed MMDs, as well as monitor the lipid-segregated DIB network. This approach provides a non-invasive, real-time analysis tool for soft matter emulsions, particularly suitable for opaque microfluidic substrates or samples that need to avoid light exposure. Future work will explore the integration of precise droplet deposition methods to analyze the configuration and reaction of the DIB network.