Focus optimization in a Computational Confocal Microscope

Keith Dillon
DOI: https://doi.org/10.48550/arXiv.2012.06677
2020-12-12
Abstract:We consider the numerical optimization of performance for a computational extension of a confocal microscope. Using a system where the pinhole detector is replaced with a detector array, we seek to exploit this additional information for each point in the scan. We derive an optimal estimate of the light at focus which minimizes the contribution of out-of-focus light. We estimate the amount of improvement that would be theoretically possible in point-scanning and line-scanning systems and demonstrate with simulation. We find that even with a large degree of regularization, a significant improvement is possible, especially for line-scanning systems.
Signal Processing,Optimization and Control,Optics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to improve image quality in computational confocal microscopy by optimizing the use of detector samples. The specific goal is to reduce the influence of out - of - focus scattered light on the image. The authors propose a method to optimize the point - spread function (PSF) of a single confocal scan point to minimize the contribution of out - of - focus light, thereby improving the performance of point - scan and line - scan systems. The paper shows through simulation that even with a large amount of regularization, the imaging effect can be significantly improved, especially in line - scan systems. ### Main research questions: 1. **Reduce the influence of out - of - focus light**: By optimizing the utilization of information at each point in the detector array, reduce the negative impact of out - of - focus light on image quality. 2. **Improve imaging performance**: Evaluate and show the theoretical improvement that can be achieved by optimizing the point - spread function (PSF) in point - scan and line - scan systems. ### Research methods: - **Model establishment**: Use Debye theory to numerically estimate the field distribution of high - numerical - aperture objective lenses and use it as the complex transfer function for illumination and detection. - **Optimization objective**: Define a "computational point - spread function" (COTF) and optimize the COTF by maximizing the ratio of in - focus light to out - of - focus light. - **Regularization treatment**: Regularize the results by truncating eigenvectors to improve robustness. ### Key formulas: 1. **Field distribution of high - numerical - aperture objective lenses**: \[ U(\mathbf{r}) = i \int_{\Omega} \sqrt{\cos \theta} e^{-ik \mathbf{s} \cdot \mathbf{r}} d\Omega \] 2. **Point - spread function (PSF)**: \[ I_0(\mathbf{r}) = \int \int |T_i(\mathbf{r}) T_d(\mathbf{r})|^2 f(\mathbf{r}) d\mathbf{r} \] 3. **Computational point - spread function (COTF)**: \[ COTF(\mathbf{r}) = \sum_{n} c_n OTF_{\Delta_n}(\mathbf{r}) \] 4. **Optimization problem**: \[ \max_{\mathbf{c}} \frac{\sum_j (T \mathbf{c})_j f_j^2}{\sum_j (T \mathbf{c})_j g_j^2} \] where \( \mathbf{f} \) and \( \mathbf{g} \) represent the in - focus and out - of - focus samples respectively. ### Conclusions: - By optimizing the utilization of information in the detector array, the imaging quality can be significantly improved without increasing the amount of data. - For point - scan systems, the optimized COTF can reduce out - of - focus light by about six times. - For line - scan systems, combining data from different scan steps can further improve performance, but the regularization parameter needs to be appropriately selected to balance performance and robustness. This research provides a new optimization method for computational confocal microscopy, which is helpful for improving imaging quality and resolution.