Abstract:We propose a new technique to fabricate a highly specialized optical element, a hybrid planar Grating/Fresnel lens (G-Fresnel), which is particularly useful to improve or enable more-affordable miniature/portable spectrometers. Both the Fresnel and the grating surface are fabricated simultaneously by sandwiching soft PDMS between a hard grating and a pre-replicated negative Fresnel surface. Several adhesion reduction techniques are also investigated that help improve both fabrication and cost efficiency (by reducing the solidification time) as well as the lifetime of the mold. Alignment errors are systematically analyzed, and their effects on the G-Fresnel lens evaluated. A compact fabrication platform was built, which is smaller than a volume of 160 x 140 x 106 mm(3) to fit into a conventional vacuum drying oven, for the fabrication of a G-Fresnel lens with a diameter of 25.4 mm, an equivalent focal length of 25 mm, and a blazed grating pattern with 600 lines/mm spacing. The solidification time was reduced to 2 hours thanks to the improved adhesion reduction technique that permits a PDMS drying-temperature as high as 65 degrees C. The fabricated G-Fresnel lens was evaluated with regard to both geometrical fabrication precision and optical performance. The measured results, using a step gauge and atomic force microscopy, confirm that this replication technique produces high-quality replicates of the master surface-profile. Furthermore, a prototype spectrometer that uses a G-Fresnel lens was built and evaluated. The spectrometer fits within a volume of about 100 mm x 50 mm x 30 mm, and it operates across a wide wavelength spectrum (450 nm to 650 nm). Both the calculation based on the optical software ZEMAX and the experimental measurements are consistent and confirm that the spectrometer with the G-Fresnel lens can provide a spectral resolution of better than 1.2 nm. (C) 2018 Optical Society of America under the terms of the OSA Open Access Publishing Agreement

Phase Fresnel Lens Development for X-ray and Gamma-ray Astronomy

Development of ground-testable phase fresnel lenses in silicon

Design and imaging performance of achromatic diffractive/refractive X-ray and Gamma-ray Fresnel lenses

Carbon-based Fresnel optics for hard x-ray astronomy

Femtosecond Laser Ablation for Manufacturing of X-ray Lenses and Phase Corrector Plates

Formation Flying for a Fresnel Lens Observatory Mission

Structure of poly(propyl ether imine) (PETIM) dendrimer from fully atomistic molecular Dynamics Simulation and by Small Angle X-ray scattering

High-efficiency multilevel zone plates for keV X-rays

Scalable, efficient ion-photon coupling with phase Fresnel lenses for large-scale quantum computing

Study on a Prototype of the Large Dimensional Refractive Lens for the Future Large Field-of-view IACT

Ion beam lithography for Fresnel zone plates in X-ray microscopy

Imaging from the Visible to the Longwave Infrared wavelengths via an inverse-designed flat lens

Efficiency and coherence preservation studies of Be refractive lenses for XFELO application

Highly Efficient Achromatic Subdiffraction Focusing Lens in the Near Field with Large Numerical Aperture

Inverse-designed flat lens for imaging in the visible & near-infrared with diameter > 3mm and NA=0.3

Modified Luneburg Lens for Achromatic Subdiffraction Focusing and Directional Emission

Improvements on Fresnel arrays for high contrast imaging

Economic fabrication of a novel hybrid planar Grating/Fresnel lens for miniature spectrometers

High-Performance Achromatic Flat Lens by Multiplexing Meta-Atoms on a Stepwise Phase Dispersion Compensation Layer

X-ray focusing with efficient high-NA multilayer Laue lenses

High-efficiency focusing and imaging by dielectric kinoform zone plate lenses with soft X-rays.