Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Towards Highly Efficient Polymer Fiber Laser Sources for Integrated Photonic Sensors

Toward On-Chip Unidirectional and Single-Mode Polymer Microlaser

Polymer-Coated Hollow Fiber Optofluidic Laser for Refractive Index Sensing

Polymer Optical Fibers for Lasing and Light Amplification

Polymer nanofibers as novel light-emitting sources and lasing material

Optofluidic laser using photostable conjugated polymer (Conference Presentation)

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Fluorescence enhanced biomolecule detection using direct laser written micro-ring resonators

Reproducible fiber optofluidic laser for disposable and array applications.

A Low Cost Photonic Biosensor Built on a Polymer Platform

Polymer-fiber Random Lasers Based on Pumping Radiation Effect

A Tunable Optofluidic Microlaser in a Photostable Conjugated Polymer

Surface Plasmon Resonance sensors based on polymer optical fiber

Stable Single‐Mode Lasing from a Hybrid Perovskite–Polymer Fiber

High-performance plasmonic lab-on-fiber sensing system constructed by universal polymer assisted transfer technique

Distributed Fibre Optofluidic Laser for Chip-Scale Arrayed Biochemical Sensing

Integrative Optofluidic Microcavity with Tubular Channels and Coupled Waveguides Via Two-Photon Polymerization

Highly Reproducible, Isotropic Optofluidic Laser Based on Hollow Optical Fiber

Recent Progress in Fiber Optofluidic Lasing and Sensing

Photopolymer self-growing technology: Towards multifunctional lab-on-fiber

Femtosecond Laser Microprinting of a Polymer Optical Fiber Interferometer for High-Sensitivity Temperature Measurement