Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

PISCES-RF: a liquid-cooled high-power steady-state helicon plasma device

Ion heating in the PISCES-RF liquid-cooled high-power, steady-state, helicon plasma device

High-power radio-frequency plasma source

Experimental Investigation on High Heat Flux Plasma Parameters of HIT-PSI Device in Argon Discharges

Design of a Water-Cooled Tube for High-Power and Long-Pulse Radio Frequency Ion Source

Plasma discharge experiments of a Faraday shieldless driver for high-power and long-pulse radio frequency ion source for NBI application

Three-dimensional Modeling of the Large and Powerful Radio Frequency Negative Hydrogen Ion Source with Faraday Shield

Design of a plasma chamber for a high-density 10 kW ECR ion source

Development and Research of a Coaxial Microwave Plasma Thruster

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies

Engineering design and manufacturing of a radio frequency plasma driver without Faraday shield for NBI application

Coupling of RF Antennas to Large Volume Helicon Plasma

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

High Rep Rate High Performance Plasma Focus As a Powerful Radiation Source

First experiments on RF plasma production at relatively low magnetic fields in the LHD

First High-Power Helicon Results From DIII-D

Development of a Compact High-Density Blue Core Helicon Plasma Device under 2000 G Magnetic Field of Ring Permanent Magnets

High duty factor plasma generator for CERN's Superconducting Proton Linac

A Table-Top Plasma Focus and Its Neutron Emission

High-Efficiency Inductively Coupled Plasma Source with Dual Antenna Hybrid Scheme

RF Helicon-based Inductive Plasma Thruster (IPT) Design for an Atmosphere-Breathing Electric Propulsion system (ABEP)