Abstract:Photonic switches have attractive application prospects in optical communication data networks that require dynamic reconfiguration. Integrating optical switching devices with optical fiber, the most widely deployed photonic technology platform, can realize signal transmission and processing in practical applications. Here, we demonstrate the multilevel optical switching using the phase-change material Ge2Sb2Te5 (GST) integrated on a graded-index multimode fiber. This switching process works by exploiting the significant difference in extinction coefficient between the crystalline state and the amorphous state of the GST. Using GST to achieve the switch function, no external energy source is needed to maintain the existing state of the switch, and the device is nonvolatile. This multi-level optical switch is an all-fiber integrated device. We apply GST to the end facets of the graded-index multimode fiber by magnetron sputtering, which is a reflective structure. A pulsing scheme is used to control the optical propagation state of the optical modulation signal to realize the switching function. It can store up to 11 non-volatile reliable and repeatable levels encoded by the pump source laser with a wavelength of 1550 nm. At the same time, the switching process between states is on the order of hundreds of nanoseconds. The present experimental results demonstrate the feasibility of 11 multilevel states in the field of optical fibers commonly used in communications. It can be well coupled with the all-fiber terminal device. It also shows that the device is still applicable in the 1525 nm∼1610 nm broadband range, promising for designing future multilevel photonic switches and memory devices.

Drive-noise tolerant optical switching inspired by composite pulses

All-optically Modulated Nonvolatile Optical Switching Based on a Graded-Index Multimode Fiber.

Compact All-Optical Switches Based on Photon-Induced Suppression of Mode Interference

Fano-resonance-based Mach-Zehnder Optical Switch Employing Dual-Bus Coupled Ring Resonator As Two-Beam Interferometer.

Synchronous Driving Scheme for Silicon-Based Optical Switches to Critically Compensate for Thermo-Optic Effect in Carrier Injection.

Low-voltage Micromachining-Based Scalable Optical Switch

Short-pulse Controlled Optical Switch Using External Cavity Based Single Mode Fabry-Pérot Laser Diode.

Polarization-insensitive Optical Switches Based on Mode-Insensitive Devices

Driving-NoiseTolerant Broadband Polymer/Silica Hybrid Thermo-Optic Switch with Low Power Consumption (vol 31, pg 299, 2012)

All-Optical 2x2 Switch by Exploiting Optical Nonlinearities in A Single Semiconductor Optical Amplifier

All-optical Switch Based on Novel Physics Effects

Optical Switches: On-Chip Optical Switch Based on Plasmon–Photon Hybrid Nanostructure-Coated Multicomponent Nanocomposite (advanced Optical Materials 8/2016)

Silicon-integrated High-Speed Mode and Polarization Switch-and-selector

All-optical Switch and Limiter Based on Nonlinear Polarization in Mach–Zehnder Interferometer Coupled with a Polarization-Maintaining Fiber-Ring Resonator

Switching in microseconds: design of a 5?×?5 non-blocking free space optical switch at 1550nm with a piezo-actuator and beam-steering lens system

Ultrafast On‐chip Remotely‐Triggered All‐Optical Switching Based on Epsilon‐Near‐Zero Nanocomposites (laser Photonics Rev. 11(5)/2017)

Large-scale optical switches by thermo-optic waveguide lens

Fabrication and Driving-Noise-tolerance Characteristics of Wide-Spectrum Polymer Thermo-Optic Switch

Femto-Joule All-Optical Switching Using Epsilon-Near-Zero High-Mobility Conductive Oxide

Investigation of Polymer-Based 1×2 All-Optical Switches at C-Band Wavelength

All-optical processing with molecular switches