Abstract:Abstract The newly built Chengdu–Guiyang Railway Gaopo Tunnel crosses through an interstratified rock mass of slightly inclined mud-sand. Sometime between the completion of the main structure and the construction of the monolithic ballast-less track, some sections began to bulge or even crack with a maximum deformation of up to 46 mm. At the same time, the vault jet concrete began to peel, causing significant risks in and challenges to the construction of the ballast-less track and the succeeding operations. In this study, the mechanism of and treatment techniques for invert floor heave following penetration of a large-cross-section tunnel into a slightly inclined stratum were investigated. In the study, the in-situ stress values and physical and mechanical parameters of the surrounding rock were obtained through field testing, and the extracted parameters were used in theoretical analysis based on discrete element numerical calculation to determine the applicable mechanism of invert floor heave. Finally, the implementation effects of different treatment techniques were compared and analyzed using the control variable method to identify final treatment measures. The results of this study reveal the following. (1) The heaving section of the invert floor in the tunnel area primarily comprised thin to medium-thick or interbedded mudstone and sandstone with argillaceous cement and was, in general, gently inclined. The joints of the rock mass were relatively well developed and broken. The effects of tectonic stress were not strong, and vertical stress was dominant. The swelling of the surrounding rock was weak. (2) The rock layer cracked as a result of the bending deformation of the layered surrounding rock in the unfavorable force direction. The argillaceous cement was lost or diluted in the presence of water. The weakening of the interlayer connection up to and including failure was an important contributory factor to the invert floor heave. (3) In treating the invert floor heave problems induced by joint surface weakening, the control effect of deepening the inversion was determined to be superior to those obtained by increasing the bolt length or strengthening the support stiffness. Based on these conclusions, a comprehensive management method involving the construction of a circular cavern using double linings and a 12-m long bolt was selected as a replacement treatment to effectively control the deformation. These results provide a reference for the design and construction of similar projects in the future.

Modified Burgers model of creep behavior of grouting-reinforced body and its long-term effect on tunnel operation

Instability Mechanism of Shallow Tunnel in Soft Rock Subjected to Surcharge Loads

A fractional-order damage creep model for grouting-reinforcement body under dry–wet cycle

Effect of Grouting Reinforcement on Settlement of Existing Tunnels: Case Study of a New Crossing Underpass

Method of Calculating the Compensation for Rectifying the Horizontal Displacement of Existing Tunnels by Grouting

Modeling of the creep and nonlinear damage effects of rocks and its application in tunnels

Analysis and numerical calculation of a coupled creep and strain-softening model for soft rock tunnels

Method of Calculating the Vertical Displacement and Additional Stress of Existing Tunnels under the Influence of Grouting Rings of New Tunnels

Investigation on the Deformation of Segment Linings in Cross-Fault Tunnel Considering the Creep Behavior of Surrounding Rock during Construction-Operation Period

Deformation and failure characteristics of a deeply buried tunnel subjected to creep slip fault movement: based on the engineering conditions of Yunnan water intake project

A double tunnels model test study on mechanical properties of surrounding rock during tunnels excavation and creep stages

Advanced Grouting Model and Influencing Factors Analysis of Tunnels with High Stress and Broken Surrounding Rock

Countermeasures against large deformation of deep-buried soft rock tunnels in areas with high geostress: A case study

Model test of excavation and double primary support time for soft rock tunnel considering creep characteristics

A Study on the Stability of Reinforced Tunnel Face Using Horizontal Pre-Grouting

Multi-stepped creep constitutive model based on asymptotic damage evolution behavior of sandstone

Model Test Studies on Ground Subsidence and Cracks Induced by Tunneling in Weak Rock Mass with High Water Content

Numerical Implementation of a Hydraulic Interaction Creep Model and Its Application to the Support Reinforcement of Water-Rich Cracked Tunnel

Experimental study on creep characteristics of glazed hollow beads-cement/sodium silicate grouting materials

Groundwater Inrush Control and Parameters Optimization of Curtain Grouting Reinforcement for the Jingzhai Tunnel

Research on the Mechanism and Treatment Technique of Invert Floor Heave After the Penetration of Large Cross-section Tunnel in Slight Inclined Stratum