Abstract:The CMS Electromagnetic Calorimeter (ECAL) is a high resolution crystal calorimeter operating at the CERN LHC. It is responsible for the identification and precise reconstruction of electrons and photons in CMS, which were crucial in the discovery and subsequent characterization of the Higgs boson. It also contributes to the reconstruction of tau leptons, jets, and calorimeter energy sums, which are vital components of many CMS physics analyses. The ECAL trigger system employs fast digital signal processing algorithms to precisely measure the energy and timing information of ECAL energy deposits recorded during LHC collisions. These trigger primitives are transmitted to the Level-1 trigger system at the LHC collisions rate of 40 MHz. These energy deposits are then combined with information from other CMS sub-detectors to determine whether the event should trigger the readout of the data from CMS to permanent storage. This presentation will summarize the ECAL trigger performance achieved during LHC Run 2 (2015-2018). It will describe the methods that are used to provide frequent calibrations of the ECAL trigger primitives during LHC operation. These are needed to account for radiation-induced changes in crystal and photodetector response, and to minimize the spurious triggering on direct signals in the photodetectors used in the barrel region ($\eta<$1.48). Both of these effects are increased relative to LHC Run 1 (2009-2012), due to the higher luminosities experienced in Run 2. Further improvements in the energy and time reconstruction of the CMS ECAL trigger primitives are being explored for LHC Run 3 (2021-23). The main features of these improved algorithms will be described and preliminary estimates of the potential performance gains will be given.

Modernization of the CMS Hadron Calorimetry at the LHC

The upgrade of the CMS electromagnetic calorimeter for HL-LHC

The upgrade of the CMS muon system for the High Luminosity LHC

CMS RPC Activities During LHC LS-2

CMS detector: Run 3 status and plans for Phase-2

Development of the CMS detector for the CERN LHC Run 3

The CMS High-Granularity Calorimeter for Operation at the High-Luminosity LHC

Cms Rpc Commissioning of the Existing Detector During the Long Shutdown

The CMS Muon System and Features of Its Operation with HL-LHC

A high energy LHC machine: experiments `first' impressions

On-beam system test of the new readout electronics for the CMS Electromagnetic Calorimeter upgrade

Upgrade of the ALICE experiment beyond LHC Run 3

The High-Level Trigger for the CMS Phase-2 Upgrade

LHC Upgrades in preparation of Run 3

Run 2 Upgrades to the CMS Level-1 Calorimeter Trigger

LHC Detector Upgrades

First Years of Running for the LHCb Calorimeter System

Resistive Plate Chambers for 2013-2014 Muon Upgrade in CMS at LHC

Optimizing the Performance of the CMS ECAL Trigger for Runs 2 and 3 of the CERN LHC

Latest results of Longevity studies on the present CMS RPC system for HL-LHC phase