Experimental Investigation of Frictional Resistance in Sliding Contact between Undulating Surfaces and Third-Body Particles

Qiang Li,Markus Heß

DOI: https://doi.org/10.3390/machines12030150

IF: 2.899

2024-02-21

Machines

Abstract:The third-body particle-involved sliding contact between two rough rubbers with wavy surfaces is experimentally studied. The experiment is designed to isolate the direct contact between the first bodies so that friction resistance is induced completely by the interactions between the third-body particle and the surfaces of the rubbers. In dry contact of a single particle, it is found that the particle exhibits pure rolling during the sliding of the first bodies, and the macroscopic friction resistance for overcoming sliding does not depend on the particle size, but it is significantly influenced by the initial position of the surface waviness relative to the particle's position. The behavior of the particle under lubricated conditions exhibited significant differences. Due to the low local friction at the interface, the particle rapidly glided down to the valley of the waviness during compression. This abrupt motion of the particle resulted in it coming to rest in a stable position, awaiting a substantial force to push it forward. The friction resistance in the case with lubrication was found to be independent of the initial position of the waviness, and its value consistently remained at the maximum found in dry contact. Therefore, lubrication actually increases the macroscopic friction resistance. An approximate solution for the specific case of dry contact is proposed to understand the friction behavior.

engineering, mechanical, electrical & electronic

What problem does this paper attempt to address?

The paper attempts to address the issue of the impact of third-body particles (i.e., particles located between two corrugated surfaces) on frictional resistance in sliding contact. Specifically, the study aims to isolate the effects of direct first-body contact through experimental methods, thereby inducing sliding friction entirely through the interaction of third-body particles with the rubber surface. The research focuses on the influence of factors such as particle size, particle quantity, surface corrugation geometry (amplitude and wavelength), initial position phase difference (ΔL), sliding speed, and lubrication conditions on macroscopic frictional resistance.

Under dry conditions, the study found that a single particle exhibits pure rolling behavior during sliding, and the macroscopic frictional resistance is independent of particle size but significantly influenced by the initial position of the surface corrugation relative to the particle position. Under lubricated conditions, due to lower local friction at the interface, particles quickly slide to the trough of the corrugation when compressed. This sudden movement causes the particles to stop at a stable position, requiring a larger force to push them forward. Therefore, lubrication actually increases macroscopic frictional resistance. The study also proposes an approximate solution to understand the friction behavior under dry conditions.