Abstract:Due to the inability of grid-following control methods to compensate for the comprehensive reduction in system inertia, strength, and short-circuit capacity caused by the decreased proportion of synchronous machines, the grid exhibits insufficient resilience to disturbances, leading to severe stability risks in terms of rotor angle, frequency, and voltage. Grid-forming inverters have emerged to address this issue. During symmetrical faults, the low-voltage ride-through of grid-forming inverters often involves freezing the reactive power loop, resulting in a direct output of higher voltage and reactive current. However, an increase in reactive power command leads to a sharp rise in the internal potential magnitude of grid-forming inverters. Upon clearance of the grid fault, the excessively high internal potential may cause a rapid, short-term increase in terminal voltage, potentially resulting in overvoltage, which is detrimental to the operation of grid-connected equipment. In response to this issue, this paper proposes an adaptive low-voltage ride-through control strategy for grid-forming inverters under symmetrical faults controlled by a virtual synchronous machine control method. Initially, a virtual synchronous machine control model is established. Limiting current is achieved through the construction of a fixed virtual impedance loop. The issues associated with fixed virtual impedance current limiting are analyzed, leading to the proposal of an adaptive virtual impedance control strategy. Finally, the feasibility of the proposed method is verified through simulation experiments.

Adaptive‐saturation‐based transient stability enhancement for grid‐following inverters

Controller-Saturation-Based Transient Stability Enhancement for Grid-Forming Inverters

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

Current Saturation Analysis and Anti-Windup Control Design of Grid-Forming Voltage Source Converter

Current Saturation Analysis of Droop Controlled Voltage Source Converter

Control Methods to Improve Virtual Power Angle Transient Stability of Droop-Controlled Inverters

Transient Stability Analysis and Control Design of Droop-Controlled Voltage Source Converters Considering Current Limitation.

Enhancement of Withstand Capability of Grid-Tied Inverters during transients, utilizing dc-side magnitudes

A Flexible Saturation Limiter for DC-Link Voltage Control of Grid-Forming Inverters with Enhanced Transient Stability

Saturation-Informed Current-Limiting Control for Grid-Forming Converters

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

A Transient Stability-Enhanced Method for Grid-Forming VSCs Considering the Current Limiting Algorithm

Transient stability improvement of grid-forming voltage source converters considering current limitation

Self-Adaptive Active Damping Method for Stability Enhancement of Systems With Black-Box Inverters Considering Operating Points

A Model Predictive Approach for Enhancing Transient Stability of Grid-Forming Converters

Transient stability enhancement control strategy for droop-controlled voltage source converter

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Transient Synchronous Stability Analysis of Grid-Following Converter Considering Outer-Loop Control with Current Limiting

Impact of Controller Saturation on Instability Behavior of Grid-Connected Inverters

Low Frequency Damping Control for Power Electronics-Based AC Grid Using Inverters with Built-In PSS