Abstract:The isotopic composition of sulfur is a vital tracer used in the Earth and planetary sciences. In this study, the laser-and ICP-induced isotopic fractionation in S-rich minerals (sulfides and elemental S) with different matrices was investigated by using 257 nm femtosecond (fs) and 193 nm ArF excimer nanosecond (ns) laser ablation systems coupled to a Neptune Plus MC-ICP-MS. Compared to ns-LA-MC-ICP-MS, higher sensitivity (1.4-2.4 times) under similar instrumental conditions and better precision (similar to 1.6-fold) under the same signal intensity condition were achieved by fs-LA-MC-ICP-MS. In addition, a fs-laser provides less fluence and matrix dependent S isotopic fractionation, and more stable transient isotopic ratios compared to a ns-laser. Better results acquired by fs-LA-MC-ICP-MS were attributed to the smaller size of particles and less thermal effect produced by using the fs-laser, which were evidenced by the morphologies of the ablation craters and ejected aerosol particles of P-S-1 (the pressed powder pellet of IAEA-S-1) and PPP-1 (a pyrite single crystal from the Sukhoi Log deposit). The ICP-induced isotopic fractionation (matrix effect) was still found in fs-LA-MC-ICP-MS under the maximum sensitivity conditions. However, a significant reduction of the matrix effect was obtained under robust plasma conditions at a lower makeup gas flow rate (0.52-0.54 l min(-1)) relative to the maximum sensitivity condition (0.6 l min(-1)) for S isotope analysis. This could be ascribed to the particles that not only pass into the higher temperature ICP for a longer residence time at a lower makeup gas flow rate that resulted in more efficient vaporization of the particles, but also experience a more robust plasma induced by adding 4-6 ml min(-1) N-2 into the plasma. Furthermore, under the robust conditions, the results of six reference materials with different matrices obtained by fs-LA-MC-ICP-MS with non-matrix matched calibration with a spot size of 20-44 mm showed excellent agreement with the reference values (the accuracy of 0.01-0.15 parts per thousand for delta S-34 and 0.11-0.45 parts per thousand for delta S-33 and the precision of 0.16-0.40 parts per thousand (2 s) for delta S-34 and 0.35-0.78 parts per thousand (2 s) for delta S-33) and the mass-dependent fractionation line, validating the applicability of the proposed approach for providing high-quality in situ isotope data (delta S-33 and delta S-34) of sulfides and elemental sulfur at high spatial resolution using non-matrix matched analysis.

A potential stibnite reference material for sulfur isotope determination by LA-MC-ICP-MS

New Potential Sphalerite, Chalcopyrite, Galena and Pyrite Reference Materials for Sulfur Isotope LA-MC-ICP-MS Determination

New Potential Sphalerite, Chalcopyrite, Galena and Pyrite Reference Materials for Sulfur Isotope Determination by Laser Ablation‐MC‐ICP‐MS

A Synthesized Sphalerite Standard for in Situ Analysis of Sulfur Isotopes and Trace Elements by LA-MC-ICP-MS and LA-ICP-MS

Three new potential sulfur reference materials (pyrite, gypsum, and arsenopyrite) for in situ sulfur isotope analysis by laser ablation MC-ICP-MS

A study on a natural pyrite sample as a potential reference material for simultaneous measurement of sulfur and iron isotopes using fs-LA-MC-ICP-MSs

Preparation of Sulfur-Bearing Reference Materials for in Situ Sulfur Isotope Measurements Using Laser Ablation Multicollector Inductively Coupled Plasma–mass Spectrometry

TC1725: a Proposed Chalcopyrite Reference Material for LA-MC-ICP-MS Sulfur Isotope Determination

A Newly Synthesized Reference Material for in Situ Sulfur Isotope Measurement of Sphalerite Using Laser Ablation MC-ICP-MS

Development of Pressed Sulfide Powder Tablets for in Situ Sulfur and Lead Isotope Measurement Using LA-MC-ICP-MS

Sphalerite and Zinc Metal Nugget Reference Materials for in Situ Zinc Isotope Ratio Determination Using Fsla‐mc‐icp‐ms

A modified laser ablation‐isotope ratio mass spectrometry method for in situ analysis of sulfur isotope composition of sulfides

Synthesis of molybdenite reference materials for in situ molybdenum and sulfur isotope measurement using laser ablation MC-ICP-MS

In-Situ Sulfur Isotopic Analysis of Sulfate by Laser Ablation Multiple Collector Inductively Coupled Plasma Mass Spectrometry (LA-MC-ICP-MS)

A Quantity Chalcopyrite Reference Material for in Situ Sulfur Isotope Analysis

A New Synthesis Scheme of Pyrite and Chalcopyrite Reference Materials for in Situ Iron and Sulfur Isotope Analysis Using LA-MC-ICP-MS

Accurate determination of sulfur isotopes (delta S-33 and delta S-34) in sulfides and elemental sulfur by femtosecond laser ablation MC-ICP-MS with non-matrix matched calibration

A High-Temperature Sintered Cassiterite Reference Material for in Situ Determination of Sn Isotope Ratios

Accurate determination of sulfur isotopes (δ33S and δ34S) in sulfides and elemental sulfur by femtosecond laser ablation MC-ICP-MS with non-matrix matched calibration

Mineralogical and Geochemical Characterization at A Micro-Scale of A New Natural Chalcopyrite Reference Material for In-Situ Fe Isotopic Ratio Analysis