Abstract:Due to the rapid development of the distribution network, there is an urgent need for high-precision state estimation and safe and stable operation, this paper proposes a joint optimal placement method for Phasor Measurement Unit (PMU) and Dual Use Line Relay (DULR) in distribution networks considering fault reconstruction and state estimation accuracy. The proposed method aims to minimize the cost of PMU and DULR configuration. Based on the known pseudo-measurements and Supervisory Control and Data Acquisition (SCADA) measurements, we use the E-optimal standard design of the state estimation error covariance matrix to form the state estimation accuracy index and take the relay protection function of Feeder Terminal Unit (FTU) device and DULR device into consideration of the fault reconstruction. By solving the mixed integer semidefinite programming (MISDP) model, the optimal placement result is obtained, so that the network under normal condition and the network after multiple fault reconstruction can meet the constraints of state estimation accuracy and load loss rate respectively. The proposed method is tested on IEEE 33-node, 123-node systems as an example. The experimental results show that the proposed method is effective and practical. Note to Practitioners— This study is stimulated by the need for optimizing the placement of Micro-PMU (μPMU) in distribution network. Since the new μPMU device DULR has the same relay protection function as FTU, and distributed generation can supply power to the island after failure, this paper adds the load loss rate to the constraint conditions to study the influence of fault reconstruction on the placement scheme. A new two-step SE method considering mixed measurements was used in this paper to improve the computational efficiency of real-time SE of large-scale system while ensuring the accuracy of the calculation results. We have conducted tests in IEEE-33 and IEEE-123 systems. After preliminary verification, compared with the single fault scenario, we find that the placement scheme considering multiple fault scenarios can effectively improve the accuracy of state estimation and reduce the load loss rate of each fault scenario and only increase the cost a little. The increase in the number of DG and contact lines in the network will also effectively improve the feasibility of the placement scheme. The increase of the number of FTU configurations can effectively reduce the configuration of DULR by adding a small amount of μ PMU, reduce the total cost as a result. In future studies, we will further consider the integrated configuration of μ PMU, DULR and FTU, to meet more failure scenarios while reducing costs.

A Hierarchical Minimum Hitting Set Calculation Method for Multiple Multiphase Faults in Power Distribution Networks

Presenting a hybrid method for fault tolerance based on neural fuzzy logic in distribution networks using phasor measurement units

Fault Location Method for Distribution Network Based on Synchronous Measurement

Fast and Accurate Method for Short-Circuit Current Calculation in Distribution Network with Iidgs

Enhancing Short-Circuit Current Calculation in Active Distribution Networks Through Fusing Superposition Theorem and Data-Driven Approach

Hybrid Approach Based On Global Search Algorithm For Optimal Placement Of Mu Pmu In Distribution Networks

Fault Diagnosis Method for Power Distribution Systems Based on Multi-source Information

MILP-Based Fault Diagnosis Model in Active Power Distribution Networks

PMU-Based Fault Location Using Voltage Measurements in Large Transmission Networks

Multiple Failures Analysis for Complex Electric Power System

Precise Fault Location in Distribution Networks Based on Optimal Monitor Allocation

Joint optimal PMU and DULR placement in distribution network considering fault reconstruction and state estimation accuracy

The Development of Fault Diagnosis Methodologies using Hierarchical Clustering and Small World Network Stratification

Hierarchical Fault Diagnosis Approach for Power Grid with Information Fusion Using Multi-data Resources

A State Estimation and Fault Processing Method Based on Big Data Analysis of Smart Distribution Network

Fault Location in Distribution Network by Solving the Optimization Problem Based on Power System Status Estimation Using the PMU

The restoration strategy for multiple faults in active distribution networks considering road‐network coupling

Current spectral norm and phase variation based fault region identification for active distribution network

Data-Driven and Interactive Fault Diagnosis of Distribution Switches

Distribution network reconfiguration during faults by path planning algorithm using minimum error current mapping technique

Novel P-Hausdorff distance-based fault diagnosis scheme for submodules in hybrid MMCs