Abstract:Due to the rapid development of the distribution network, there is an urgent need for high-precision state estimation and safe and stable operation, this paper proposes a joint optimal placement method for Phasor Measurement Unit (PMU) and Dual Use Line Relay (DULR) in distribution networks considering fault reconstruction and state estimation accuracy. The proposed method aims to minimize the cost of PMU and DULR configuration. Based on the known pseudo-measurements and Supervisory Control and Data Acquisition (SCADA) measurements, we use the E-optimal standard design of the state estimation error covariance matrix to form the state estimation accuracy index and take the relay protection function of Feeder Terminal Unit (FTU) device and DULR device into consideration of the fault reconstruction. By solving the mixed integer semidefinite programming (MISDP) model, the optimal placement result is obtained, so that the network under normal condition and the network after multiple fault reconstruction can meet the constraints of state estimation accuracy and load loss rate respectively. The proposed method is tested on IEEE 33-node, 123-node systems as an example. The experimental results show that the proposed method is effective and practical. Note to Practitioners— This study is stimulated by the need for optimizing the placement of Micro-PMU (μPMU) in distribution network. Since the new μPMU device DULR has the same relay protection function as FTU, and distributed generation can supply power to the island after failure, this paper adds the load loss rate to the constraint conditions to study the influence of fault reconstruction on the placement scheme. A new two-step SE method considering mixed measurements was used in this paper to improve the computational efficiency of real-time SE of large-scale system while ensuring the accuracy of the calculation results. We have conducted tests in IEEE-33 and IEEE-123 systems. After preliminary verification, compared with the single fault scenario, we find that the placement scheme considering multiple fault scenarios can effectively improve the accuracy of state estimation and reduce the load loss rate of each fault scenario and only increase the cost a little. The increase in the number of DG and contact lines in the network will also effectively improve the feasibility of the placement scheme. The increase of the number of FTU configurations can effectively reduce the configuration of DULR by adding a small amount of μ PMU, reduce the total cost as a result. In future studies, we will further consider the integrated configuration of μ PMU, DULR and FTU, to meet more failure scenarios while reducing costs.

Hybrid Approach Based On Global Search Algorithm For Optimal Placement Of Mu Pmu In Distribution Networks

Customized optimal μPMU Placement method for distribution networks

Two-stage optimal PMU placement for distribution systems

Micro Pmu Based Monitoring System For Active Distribution Networks

Optimal PMU Placement Approach for Power Systems Considering Non-Gaussian Measurement Noise Statistics

A 0-1 Linear Programming Approach to Optimal Phasor Measurement Units Placement Considering Maximized System Observability Redundancy

A Substation-Oriented Approach to Optimal Phasor Measurement Units Placement

Optimal Placement of Distribution-Level Synchrophasor Sensors for Distribution System

PMU-Based Fault Location Using Voltage Measurements in Large Transmission Networks

A Multiobjective Intelligent Decision-Making Method for Multistage Placement of PMU in Power Grid Enterprises

Optimal Placement of Phasor Measurement Unit Based on Multi-Objective Evolutionary Algorithm

Presenting a hybrid method for fault tolerance based on neural fuzzy logic in distribution networks using phasor measurement units

Full Coverage of Optimal Phasor Measurement Unit Placement Solutions in Distribution Systems Using Integer Linear Programming

Joint optimal PMU and DULR placement in distribution network considering fault reconstruction and state estimation accuracy

Optimum Placement of Phasor Measurement Units in Power Systems.

State estimation for distribution systems using micro-synchrophasors

Optimal PMU Placement to Guarantee Observability under N-1 Condition

Investigation of optimal PMU placement considering limited number of channels constraints and critical line constraints

Research on μPMU Configuration Optimization Considering Multiple Operation Modes of Distribution Network

Optimal PMU placement for modeling power grid observability with mathematical programming methods

Fault Location in Distribution Network by Solving the Optimization Problem Based on Power System Status Estimation Using the PMU