Effect of water-based ultrasonic vibration on the quality of laser trepanned microholes in nickel super-alloy workpieces
Houxiao Wang,Lin Li,Sukai Zhu,Ye Xu,Naifei Ren
DOI: https://doi.org/10.1016/j.jmatprotec.2019.04.034
IF: 6.3
2019-10-01
Journal of Materials Processing Technology
Abstract:<p>Effusion cooling holes are commonly drilled in nickel super-alloy aero-engine components using electro-discharge machining (EDM) or pulsed laser drilling. While drilling quality of EDM is high, its machining efficiency is normally relatively low, without mentioning its high tooling cost. The drilling efficiency of a millisecond pulsed laser is much higher, while a recast layer often forms on hole wall. In this paper, an ultrasonic-assisted laser trepanning technology is reported for trepanning blind and through holes in nickel super-alloy samples. The influence of ultrasonic vibrations on hole geometry, morphology, microstructure, recast layer thickness and mechanical performance was investigated through comparing holes trepanned without ultrasonic assistance. The effects of trepanning speed, number of trepanning passes and pulse duration on heat affected zone (HAZ), microstructure, micro hardness of recast layer and HAZ, and recast layer thickness were also discussed. It was found that ultrasonic vibrations contributed to laser trepanning process mainly by means of grain refinement strengthening, hard phase precipitation and dispersion strengthening, recast layer reduction, and negative taper for the through hole trepanned. The percentage of the measured recast layer reduction induced by ultrasonic vibrations approximately ranged from 15.73% to 31.82%. Besides, a maximum percentage of around 19.43% was achieved for micro hardness improvement induced by ultrasonic vibrations. However, the width of laser trepanned HAZ was increased around 36.00% due to ultrasonic vibration assistance, indicating the micro hardness was improved in a larger domain surrounding the trepanned hole. In addition, the HAZ grains, near the recast layer, was further refined via increasing trepanning speed, decreasing pulse width. Compared with the base metal, the impact toughness was increased by using ultrasonic-enhanced laser trepanning mainly due to grain refinement strengthening.</p>
materials science, multidisciplinary,engineering, manufacturing, industrial