Characterization of AlW oxide coatings on aluminum formed by pulsed direct current plasma electrolytic oxidation at ultralow duty cycles

Kristina Mojsilovic,nenad Tadic,Uros Lacnjevac,Stevan Stojadinovic,Rastko Vasilic

DOI: https://doi.org/10.48550/arXiv.2210.15719

IF: 2.552

2022-10-27

Chemical Physics

Abstract:The growth of thin oxide coatings on the aluminum substrate in water-based sodium tungstate electrolyte by plasma electrolytic oxidation (PEO) is discussed and experimentally illustrated. The growth is carried out using a distinctive ultra-low duty cycle pulsed direct current (DC) power supply. During the PEO processing elements present in micro-discharges are identified using standard optical emission spectroscopy (OES) technique. The spectral line shape analysis of the first two hydrogen Balmer lines shows the presence of two types of micro-discharges. Obtained coatings are also characterized with respect to their morphology and chemical and phase composition. It is shown that coatings are composed of Al, O, and W, featuring low roughness and porosity. Partial crystallization of the coatings resulted in identification of WO3, W3O8, and gamma-Al2O3 crystalline phases.

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to study the characteristics of oxide coatings generated by plasma electrolytic oxidation (PEO) technology on high - purity aluminum under the condition of ultra - low duty cycle with pulsed direct current (DC) power supply. Specifically, the author hopes to explore the following aspects through experimental and characterization methods:

1. **Micro - discharge characteristics**: Use standard optical emission spectroscopy (OES) technology to identify the elements present in the micro - discharge process, and analyze the spectral shapes of the first and second lines of the hydrogen Balmer series to reveal two types of micro - discharges.

2. **Morphology and composition of the coating**: Study the surface morphology, chemical composition and phase composition of the obtained coating by means of scanning electron microscopy (SEM), energy - dispersive spectroscopy (EDS) and X - ray diffraction (XRD). Pay special attention to the existence forms and distributions of Al, O and W elements in the coating.

3. **Crystal structure changes**: Confirm the partial crystallization phenomenon, including the formation of WO₃, W₃O₈ and α - Al₂O₃ crystal phases, and explore the relationships between these crystal phases and the processing conditions.

4. **Influence of process parameters**: Evaluate the influence of different treatment times (10 minutes, 20 minutes, 30 minutes) and pulse widths (ton = 5 ms, 10 ms, 20 ms) on the coating properties, such as the changes in porosity, roughness and thickness.

In summary, this research aims to explore the influence of a novel ultra - low - duty - cycle pulsed DC power supply on the oxide coating on the surface of high - purity aluminum during the PEO process, and deeply understand the change rules of its microscopic mechanism and macroscopic properties through a variety of characterization means. This will not only help to optimize the PEO process parameters, but also provide theoretical basis and technical support for the development of functional coatings with better anti - corrosion and wear - resistant properties.