Research on spectral signal calibration method of ink composition test system based on composite filter

Ziqiang He,Rui Zhang,Bu Ning,Jibin Zhao,Guangyao Cheng

DOI: https://doi.org/10.1016/j.ijleo.2020.164946

IF: 3.1

2020-08-01

Optik

Abstract:<p>In spectral information acquisition, the removal of stray light, noise, and other signals in the spectral system have always been an important part of the research. In this paper, the removal technology of stray light, noise, and other signals in the development of an ink testing system based on visible spectrum technology is deeply studied. Then, by researching composite digital filtering, curve fitting algorithm, and the fitting equation peak-seeking calibration method, a system for dynamically collecting grating spectral information is designed, which effectively improves the system's detection and extraction accuracy of light source signals. The experimental results show that the composite digital filtering method of moving average filtering and median filtering can not only suppress the accidental pulse interference, but also effectively filter out the observable random noise. For spectral information after filtering, the 6th order Gaussian algorithm was used to fit the acquired signal of the light source, and the R-square value and RMSE value were 0.9867 and 0.0277 respectively, showing better fitting accuracy and reduction degree. Finally, the fitting equation peak-seeking calibration method is adopted based on least square method. The experimental results show that the maximum error is 0.0045nm and the RMSE value is 0.0029. The system shows better calibration accuracy.</p>

optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the limited ability to remove stray light, noise and other signals in the development of an ink component testing system based on visible - spectrum technology. Specifically, the paper focuses on how to improve the collection speed and calibration accuracy of the light source signal by designing a dynamic grating spectral collection system. This system adopts a composite digital filtering method, a curve - fitting algorithm and a peak - finding calibration method for the fitting equation. These methods aim to effectively suppress interference factors that are difficult to handle with traditional filtering, such as stray light and current, and improve the measurement accuracy of the system.