Abstract:In order to study the mechanical properties of seawater sea sand concrete and the durability damage law of seawater sea sand concrete under the action of seawater erosion, corresponding specimens were prepared and subjected to cube compressive strength, flexural strength, and dry-wet cycle tests by taking the volume dosage of glass fibers and polyvinyl alcohol fibers as variables. The test combined SEM scanning and EDS to analyze the microstructure of fiber-reinforced seawater sand concrete, and established a model based on the two-parameter Weibull probability distribution. The results show that the fiber has a significant effect on improving the mechanical properties and erosion resistance of seawater sand concrete. When the total volume content is 0.3% and the mixing ratio is 1:1, the improvement effect is the best. The maximum increase in cubic compressive strength was 24.2%; the maximum increase in flexural strength was 38.8%. After the specimens were subjected to wet and dry cycles for 360d, the maximum reduction in mass loss rate was 41.23%; the maximum reduction in strength loss rate was 27.55%. As observed from the microscopic images, the main disadvantage of SSC is that the salt crystallization and swelling matter produced by the erosion ions will weaken the bond between aggregate and mortar, resulting in defects in the interfacial transition zone (ITZ). Under the action of dry-wet cycles, the alternating dry-wet forces, the expansion pressure generated by expansive substances and the crystallization pressure generated by salt crystallization will change the microstructure, and therefore the damage of the specimen will deepen with the extension of erosion time. The microscopic images also show that the doping fibers can improve the internal integrity and compactness of the matrix, thus significantly improving the mechanical properties and durability of seawater sea sand concrete. In this test, a damage model was established based on the two-parameter Weibull distribution model, and the damage law between strength loss and dry-wet cycles was fitted, which provides a favorable basis to study the damage of seawater sea sand concrete under wet-dry cycling.

Modelling damage evolution of carbon fiber-reinforced epoxy polymer composites in seawater sea sand concrete environment

Continuum Damage Modeling and Progressive Failure Analysis of Carbon Fiber/epoxy Composite Pressure Vessel

A Corrosion Cracking Mechanism-Based Model with Molten Salt Corrosion Damage Coupling the Effect of Chloride Impurity and Plastic Deformation

CFRP Strengthened RC Beams with Pre-Strengthening Non-Uniform Reinforcement Corrosion Subjected to Post-Strengthening Wetting/drying Cycles

Degradation of GFRP Bars with Epoxy and Vinyl Ester Matrices in a Marine Concrete Environment: an Experimental Study and Theoretical Modeling

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Influence of Erosion Damage on the Spatiotemporal Deterioration of Marine RC Structures

Effects of exposure in seawater sea-sand concrete pore solution on fatigue performance of carbon FRP bars

Corrosion Development of Carbon Steel Grids and Shear Connectors in Cracked Composite Beams Exposed to Wet-Dry Cycles in Chloride Environment.

Effect of seawater and stress coupling on the durability of carbon fibre-reinforced polymer

Characterization of material degradation mechanism of carbon fiber reinforced epoxy resin composites under ultraviolet radiation and salt‐fog synergistic environment

Data-driven Corrosion Failure Probabilistic Assessment Model for Reinforced Concrete Structures

Study on mechanical properties and anti-erosion performance of fiber reinforced seawater sea sand concrete

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

Modelling of the damage development in carbon/epoxy laminates subjected to combined seawater ageing and mechanical loading

Experimental Study on the Mechanical Properties of CFRP/epoxy Composite Plates under Seawater Immersion

Modeling and simulation of corrosion mechanism for glass fiber reinforced plastic in sea water

Physicochemical-mechanical simulation of the short- and long-term performance of FRP reinforced concrete beams under marine environments

Durability and microstructure degradation mechanism of FRP-seawater seasand concrete structures: A review

Effects of Exposure in Seawater Sea-Sand Concrete Environment on Fatigue Performance of Carbon Fibre Reinforced Polymer Rebars

Experimental characterization and numerical prediction for mechanical aging of epoxy and its carbon fiber‐reinforced composite under hydrothermal conditions