Abstract:Big Data Analysis from the worldwide field shows that lost circulation is a common phenomenon in drilling and the success ratio of remedial treatment for lost circulation is low. It is not only because of these complexities of the formation, but also because of the poor performances of the lost-circulation materials (LCM) and technologies. This paper proposes a new method in plugging, which is based on a particular physical method for lost circulation controlling and plugging while drilling. This method is different from these traditional treatments, which only use chemical methods. When pore-permeable and fractured leakage formations are encountered while drilling, We can use this new hydraulic tool, the drilling fluid will have a diffluence at a constant rate from the jet of the hydraulic tool which is installed on the drilling pipe and the fluid laden with particles can be injected into the natural or induced fractures of the borehole wall which may lead to lost circulation. Combined with the corresponding drilling fluids which have been tested in the laboratory, the additives such as ground marble, ground nutshells, and graphite in the drilling fluid are quickly pushed into the fractures because of the differential pressure provide by the hydraulic tool, then form a firm seal at the mouth of the fractures which could isolate fluid pressure in the wellbore and prevent effective pressure communication to interfere the extension of the fracture. What's more, according to the stress cage theory, when these sealing particles which prop the fracture open, act as wedges to compress the rock around the wellbore, the hoop stress could be increased, so that the wellbore pressure containment (WPC) could be improved. Since the annular flow may have some interference with the side nozzle jet, this paper also numerically simulates the flow field of the annular air section through the fluid simulation software Fluent, and the simulation results show that the interference of the annular flow on the jet is very weak and basically has no effect. In addition, through the oilfield field test, it is known that this new physical plugging method has good plugging effect, and it can obviously improve the pressure-bearing capacity of the formation, which has great popularization value.

Optimisation of drainage performance of the thin-walled core barrel sealing technology for pressure preservation sampling

A Long-distance Pushing and Rotary Equipment for Natural Gas Hydrate Pressure Core

Scheme design and performance analysis of thin-walled pressure-retaining coring tools for seafloor drills in the deep-sea operating environment

Optimizing Preloading Pressure of Pre-Charged Gas for Isobaric Gas-Tight Hydrothermal Samplers

A Long-stroke Pushing and Rotating Device for Seafloor Natural Gas Hydrate Pressure Core

Design and Experimental Study of an Improved Pressure Core Sampler for Marine Gas Hydrates

Development of Pressure Piston Corer for Exploring Natural Gas Hydrates

Research on Pressure Tight Sampling Technique of Deep-Sea Shallow Sediment - A New Approach to Gas Hydrate Investigation

Development and Application of Water Sealing Technology for Gas Drainage Boreholes

Research and Analysis of 30-m Gravity Piston Corer for Natural Gas Hydrate

Scheme design and flow performance analysis of double-bits combination wire-line coring technology for seafloor drill

In-situ pressure-preserved coring for deep exploration: Insight into the rotation behavior of the valve cover of a pressure controller

Novel Designs of Pressure Controllers to Enhance the Upper Pressure Limit for Gas-Hydrate-bearing Sediment Sampling

Natural Gas Hydrate:a Drilling and Coring Technique Different from the Deep-Sea Pressure- and Temperature-Preservation Method of DSDP-ODP

In-situ Ultrasonic Measurement for Hydrate Pressure Cores Sampled by Deep Sea Drilling

Reliability Analysis of Dynamic Sealing Performance in the Radial Hydraulic Drilling Technique

An optimization method of fidelity parameters of formation fluid sampling cylinder while drilling

Research on pressure characteristic of pressure-retaining subsampling device of natural gas hydrate

Pressure Tight Piston Corer—A New Approach on Gas Hydrate Investigation

Design and experimental study of a new hydraulic tool for lost-circulation materials (LCM) plugging while drilling

Determination of gas-water seepage characteristics with consideration of dynamic pore-throat structure in a tight sandstone gas formation