Abstract:Volatile organic compounds (VOCs) are one of the major components of air pollution. Catalytic combustion is a promising technology for the treatment of VOCs and at its center is the preparation of efficient and cheap catalysts. In this study, by loading copper (Cu) and manganese (Mn) on Santa Barbara Amorphous-15 (SBA-15) molecular sieve, the Cu x –Mn y /SBA-15 ( x = 1, 2; y = 1, 2) composite metal oxide catalyst was prepared using the equal volume impregnation method. Their performance in the toluene catalytic combustion reaction was investigated by adjusting the molar ratio ( x : y ), and the loading of Cu and Mn. The results of the Brunner–Emmett–Teller (BET), X-ray diffraction (XRD), scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS) analyses show that the CuMnO spinel phase can be detected in the Cu–Mn composite metal oxide catalyst doped with a low concentration of Cu. The overall rod-like structure of the fibrous network structure provides a large specific surface area, and the particle crystallinity is low and the dispersion is good. Due to the synergistic effect of Cu and Mn, the greater the amount of Mn 3+ and adsorbed oxygen species (O ads ) that are available, and the higher the turnover frequency (TOF) value, the better and more superior catalytic performance and excellent stability is obtained, when compared with the single-component oxides used in toluene catalytic combustion. After a continuous catalytic reaction for 12 h, the toluene conversion rate remained above 95%. The coupling effect of the catalytic reaction temperature and concentration of oxygen on the catalytic combustion of toluene was also studied. At a low reaction temperature (<250 °C), the increase of the concentration of oxygen played a superior role in promoting the conversion of toluene. The kinetic analysis of the toluene catalytic combustion process showed that the catalytic combustion of toluene by Cu–Mn/SBA-15 followed both the Mars–Van Krevelen (MVK) and Langmuir–Hinshelwood (L–H) reaction mechanisms. With the increase of the O ads amount caused by the decrease of the Cu ratio, the proportion of the L–H reaction mechanism increases.

Preparation of Nanosized Copper–Manganese Composite Oxides and Their Catalytic Performance in the Oxidation of Toluene

Enhancement of Toluene Removal over Α@δ-Mno2 Composites Prepared Via One-Pot by Modifying the Molar Ratio of KMnO4 to MnSO4·H2O

Enhanced Catalytic Activity of Toluene Oxidation over In-Situ Prepared Mn3O4-Fe2O3 with Acid-Etching Treatment

Nanoporous CeO2-Decorated Cu-SmMn2O5 Composite Mullite Oxide Catalyst for Toluene Oxidation

Facile synthesis of homogeneous hollow microsphere Cu-Mn based catalysts for catalytic oxidation of toluene

Nanoporous CeO 2 -Decorated Cu-SmMn 2 O 5 Composite Mullite Oxide Catalyst for Toluene Oxidation

Nanosheet-state cobalt-manganese oxide with multifarious active regions derived from oxidation-etching of metal organic framework precursor for catalytic combustion of toluene

Bamboo-like MnO2⋅Co3O4: High-performance catalysts for the oxidative removal of toluene

Modulated synthesis of MnO2-decorated Fe–Mn composite oxides:synergistic effects on boosting the performance of toluene oxidation

Total oxidation of toluene at low temperatures in air using sono-impregnated Mn/Cu bimetal over activated clinoptilolite as a nanocatalyst: Designing the oxidation reaction rate with the optimization of the fixed bed reactor CFD model

One-pot solvothermal synthesis of highly dispersed, morphology- and crystal structure-tunable copper-manganese oxide for catalytic combustion of toluene at low temperatures

Liquid-phase oxidation of toluene by molecular oxygen over copper manganese oxides

Coupling effect of reaction conditions on the catalytic activity of Cu–Mn composite oxide catalysts for toluene

Preparation of MnO2 decorated Co3Fe1O powder/monolithic catalyst with improved catalytic activity for toluene oxidation

Fabrication of acid-activated dispersive palygorskite nanorods supported copper manganese composite oxide for catalytic oxidation of toluene

Mesoporous manganese oxide nanoparticles for the catalytic total oxidation of toluene

Insight into the catalytic performance and reaction routes for toluene total oxidation over facilely prepared Mn-Cu bimetallic oxide catalysts

Oxidation of Toluene over Mesoporous MnO2/CeO2 Nanosphere Catalysts: Effects of the MnO2 Precursor and the Type of Support

Enhanced catalytic toluene oxidation by interaction between copper oxide and manganese oxide in Cu-O-Mn/γ-Al2O3 catalysts

MCM-41 supported Cu-Mn catalysts for catalytic oxidation of toluene at low temperatures.

Ag-Doped δ-MnO 2 Nanosheets as Robust Catalysts for Toluene Combustion