Abstract:Volatile organic compounds (VOCs) are one of the major components of air pollution. Catalytic combustion is a promising technology for the treatment of VOCs and at its center is the preparation of efficient and cheap catalysts. In this study, by loading copper (Cu) and manganese (Mn) on Santa Barbara Amorphous-15 (SBA-15) molecular sieve, the Cu x –Mn y /SBA-15 ( x = 1, 2; y = 1, 2) composite metal oxide catalyst was prepared using the equal volume impregnation method. Their performance in the toluene catalytic combustion reaction was investigated by adjusting the molar ratio ( x : y ), and the loading of Cu and Mn. The results of the Brunner–Emmett–Teller (BET), X-ray diffraction (XRD), scanning electron microscopy (SEM), and X-ray photoelectron spectroscopy (XPS) analyses show that the CuMnO spinel phase can be detected in the Cu–Mn composite metal oxide catalyst doped with a low concentration of Cu. The overall rod-like structure of the fibrous network structure provides a large specific surface area, and the particle crystallinity is low and the dispersion is good. Due to the synergistic effect of Cu and Mn, the greater the amount of Mn 3+ and adsorbed oxygen species (O ads ) that are available, and the higher the turnover frequency (TOF) value, the better and more superior catalytic performance and excellent stability is obtained, when compared with the single-component oxides used in toluene catalytic combustion. After a continuous catalytic reaction for 12 h, the toluene conversion rate remained above 95%. The coupling effect of the catalytic reaction temperature and concentration of oxygen on the catalytic combustion of toluene was also studied. At a low reaction temperature (<250 °C), the increase of the concentration of oxygen played a superior role in promoting the conversion of toluene. The kinetic analysis of the toluene catalytic combustion process showed that the catalytic combustion of toluene by Cu–Mn/SBA-15 followed both the Mars–Van Krevelen (MVK) and Langmuir–Hinshelwood (L–H) reaction mechanisms. With the increase of the O ads amount caused by the decrease of the Cu ratio, the proportion of the L–H reaction mechanism increases.

One-pot solvothermal synthesis of highly dispersed, morphology- and crystal structure-tunable copper-manganese oxide for catalytic combustion of toluene at low temperatures

One-pot synthesis of dual-phase manganese dioxide for toluene removal: Effect of crystal phase blending level on oxygen species and activity

Enhancement of Toluene Removal over Α@δ-Mno2 Composites Prepared Via One-Pot by Modifying the Molar Ratio of KMnO4 to MnSO4·H2O

Enhanced catalytic oxidation of toluene over manganese-based multi-metal oxides synthesized by ozone driving redox reaction

Toluene Catalytic Combustion over Copper Modified Mn0.5Ce0.5 Ox Solid Solution Sponge-Like Structures

Redox-Induced In Situ Growth of MnO2 with Rich Oxygen Vacancies over Monolithic Copper Foam for Boosting Toluene Combustion

Facile synthesis of homogeneous hollow microsphere Cu-Mn based catalysts for catalytic oxidation of toluene

Low-Temperature Combustion of Toluene over Cu-Doped SmMn<sub>2</sub>O<sub>5</sub> Mullite Catalysts via Creating Highly Active Cu<SUP>2+</SUP>-O-Mn<SUP>4+</SUP> Sites

Modulated synthesis of MnO2-decorated Fe–Mn composite oxides:synergistic effects on boosting the performance of toluene oxidation

Liquid-phase oxidation of toluene by molecular oxygen over copper manganese oxides

Nanosheet-state cobalt-manganese oxide with multifarious active regions derived from oxidation-etching of metal organic framework precursor for catalytic combustion of toluene

Preparation of Nanosized Copper–Manganese Composite Oxides and Their Catalytic Performance in the Oxidation of Toluene

Biostarch-assisted synthesis of microscopic heterogeneous manganese-cobalt oxides for efficient catalytic combustion of toluene

Coupling effect of reaction conditions on the catalytic activity of Cu–Mn composite oxide catalysts for toluene

Facile synthesis of a CuMnO<sub><i>x</i></sub> catalyst based on a mechanochemical redox process for efficient and stable CO oxidation

In Situ Fabrication of Highly Dispersed Co-Fe-Doped-δ-MnO2 Catalyst by a Facile Redox-Driving MOFs-Derived Method for Low-Temperature Oxidation of Toluene.

Copper Doped Manganese Oxides to Produce Enhanced Catalytic Performance for CO Oxidation

Tuning the crystallinity of the MnOx catalysts to promote toluene catalytic oxidation

Insight into the catalytic performance and reaction routes for toluene total oxidation over facilely prepared Mn-Cu bimetallic oxide catalysts

Transition Metal Modified Manganese-based Catalysts for Soot Oxidation Promoted by Noncompetitive Adsorption of Oxygen: Experiments and DFT Calculations

Insights into key parameters of MnO2 catalyst toward high catalytic combustion performance