Abstract:The CDEX (China Dark matter Experiment) is currently in the stage to upgrade to approximately 10 kg HPGe (High Purity Germanium) detectors (CDEX-10) in CJPL (China Jinping Underground Laboratory) and aims to detect the WIMP (Weakly Interacting Massive Particles). Six analog signals and one inhibited signal are outputted from preamplifier by one HPGe detector (∼ 1 kg) of CDEX-10. The analog signals are conditioned with two 6 μs and one 12 μs shaping amplifiers, and three timing amplifiers respectively. The inhibited signal is used for trigger. The analog signals from shaping and timing amplifiers are digitized to obtain energy spectrum and rise-time distribution. The rise-time distribution is used to discriminate surface, bulk, and very bulk events, which can help to supress the background level in dark matter detection. Composed of commercial modules, the previous DAQ (Data Acquisition Systems) is insufficient in discriminating between bulk and very bulk events due to the limited sampling rate (100 MSPS). Besides, as number of channel increases, the system will be simplified by integrating the trigger logic in FPGA (Field Programmable Gate Array). In this paper, a prototype named RAIN4HPGe is designed with pulse digitizer and readout electronics, integrating 14-bit 100 MSPS ADCs (Analog-to-Digital Converters), 12-bit 1 GSPS ADCs, FPGA etc. . The RAIN1000Z1 readout module based on ZYNQ SoC (System on Chip) is used for readout over Gigabit Ethernet. Better energy resolution, e.g. improving from 558 eV to 474 eV @122 keV, can be achieved by RAIN4HPGe compared to previous DAQ (Data Acquisition Systems) with commercial solution. Moreover, the discrimination performance of bulk, and very bulk events has been improved by RAIN4HPGe with 1 GSPS ADC.

A Prototype PCI-based Data Acquisition System for Cosmic Ray Detection Below 10^18 eV

Data Acquisition System for CEPC Vertex Detector Prototype

Design and preliminary performance of a novel mixed-signal front-end electronics with post digital shaping for CZT detectors

Design of a Multichannel 10~14 Bits, 1 MSamples/s, Event-Driven Single-Slope Ramp ADC for Dark Matter Particle Detection

Design and Performance of a 16-Channel Radiation-Hardened Low-Noise Front-End Readout ASIC for CZT-based Hard X-ray Imager

A Low Noise Apd Readout Asic For Electromagnetic Calorimeter In Hiepa

Advanced Readout Electronics System for Portable Cosmic Ray Muon Detection

Development of a modular and scalable data acquisition system for calorimeters at a linear collider

A radiation-hard dual-channel 12-bit 40 MS/s ADC prototype for the ATLAS liquid argon calorimeter readout electronics upgrade at the CERN LHC

SAMPA Based Streaming Readout Data Acquisition Prototype

Low-cost data acquisition card for school-network cosmic ray detectors

Design of a Common High-Performance Data Acquisition System for Physics Experiments at HIAF

Casca: A Readout Asic For A Tpc Based X-Ray Polarimeter

Design of a Readout Circuit Chip for a Cosmic Ray Muon Detector with Multi-Angular Acceptance

Hybrid Portable Low-cost and Modular Cosmic Ray Muon and Neutron Detector

A Generic High Bandwidth Data Acquisition Card for Physics Experiments.

Prototype of Pulse Digitizer and Readout Electronics for CDEX-10 in CJPL

Position Encoding Readout Electronics Of Large Area Micromegas Detectors Aiming For Cosmic Ray Muon Imaging

Design of the readout electronics system with high event rate based on the Micromegas Detector

The ultrafast pixel array camera system and its applications in high energy density physics

The CuboDAQ Data Acquisition System