Abstract:The solidification mechanism and segregation behavior of laser-melted Mn35Fe5Co20Ni20Cu20 was firstly investigated via in situ synchrotron x-ray diffraction at millisecond temporal resolution. The transient composition evolution of the random solid solution during sequential solidification of dendritic and interdendritic regions complicates the analysis of synchrotron diffraction data via any single conventional tool, such as Rietveld refinement. Therefore, a novel approach combining a hard-sphere approximation model, thermodynamic simulation, thermal expansion measurement and microstructural characterization was developed to assist in a fundamental understanding of the evolution of local composition, lattice parameter, and dendrite volume fraction corresponding to the diffraction data. This methodology yields self-consistent results across different methods. Via this approach, four distinct stages were identified, including: (I) FCC dendrite solidification, (II) solidification of FCC interdendritic region, (III) solid-state interdiffusion and (IV) final cooling with marginal diffusion. It was found out that in Stage I, Cu and Mn were rejected into liquid as Mn35Fe5Co20Ni20Cu20 solidified dendritically. During Stage II, the lattice parameter disparity between dendrite and interdendritic region escalated as Cu and Mn continued segregating into the interdendritic region. After complete solidification, during Stage III, the lattice parameter disparity gradually decreases, demonstrating a degree of composition homogenization. The volume fraction of dendrites slightly grew from 58.3 to 65.5%, based on the evolving composition profile across a dendrite/interdendritic interface in diffusion calculations. Postmortem metallography further confirmed that dendrites have a volume fraction of 64.7% ± 5.3% in the final microstructure.

XRD investigation of binary alloy solidification

Effect of Directional Solidification Methods on Solid Solution Window in Ni-based Single-Crystal Superalloy

Solidification Microstructure in a Supercooled Binary Alloy

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

In-situ X-ray diffraction study on dealloying: A scenario of a Cu90Au10 alloy

The Effect of In Concentration and Temperature on Dissolution and Precipitation in Sn–Bi Alloys

Microgravity studies of solidification patterns in model transparent alloys onboard the International Space Station

In situ synchrotron diffraction and modeling of non-equilibrium solidification of a MnFeCoNiCu alloy

Crystallization and phase separations in amorphous Cu12.5Ni10Zr41Ti14Be22.5 alloy, as investigated by sans

Temperature-Induced Structural Changes in the Liquid GaInSn Eutectic Alloy

Lead-Bismuth Eutectic: Atomic and Micro-Scale Melt Evolution

Isothermal furnace for long-term in situ and real-time X-radiography solidification experiments

Temperature Dependent Structural Evolution in Liquid Ag50Ga50 Alloy.

In Situ X-Ray Radiography and Tomography Observations of the Solidification of Alumina Particles Suspensions. Part I: Initial Instants

Dynamics and microstructural evolution of bulk amorphous Cu 12.5 Ni 10 Zr 41 Ti 14 Be 22.5 during phase separations: a small-angle neutron scattering approach

Microstructural Investigations of Ni-Based Superalloys by Directional Solidification Quenching Technique

Phase Transformations and Mechanical Properties in In–Bi–Sn Alloys as a Result of Low-Temperature Storage

Crystallization and Phase Separation of Amorphous Cu12.5Ni10Zr41Ti14Be22.5 Around the Crystallization Point As Investigated by SANS

Metastable Liquid Properties and Surface Flow Patterns of Ultrahigh Temperature Alloys Explored In Outer Space

Experimental and molecular dynamics simulation study of structure of liquid and amorphous Ni62Nb38 alloy

Influence of Minor Cr Additions on Crystal Growth in Rapidly Solidified Al-20Zn Alloys