Abstract:Storage is still limiting the implementation of hydrogen as an energy carrier to integrate the intermittent operation of renewable energy sources. Among different solutions to the currently used compressed or liquified hydrogen systems, physical adsorption at cryogenic temperature in porous materials is an attractive alternative due to its fast and reversible operation and the resulting reduction in storage pressure. The feasibility of cryoadsorption for hydrogen storage depends mainly on the performance of the used materials for the specific application, where metal-organic frameworks or MOFs are remarkable candidates. In this work, gravimetric and volumetric hydrogen uptakes at 77 K and up to 100 bar of commercially available MOFs were measured since these materials are made from relatively cheap and accessible building blocks. These materials also show relatively high porous properties and are currently near to large-scale production. The measuring device was calibrated at different room temperatures to calculate an average correction factor and standard deviation so that the correction deviation is included in the measurement error for better comparability with different measurements. The influence of measurement conditions was also studied, concluding that the available adsorbing area of material and the occupied volume of the sample are the most critical factors for a reproducible measurement, apart from the samples’ preparation before measurement. Finally, the actual volumetric storage density of the used powders was calculated by directly measuring their volume in the analysis cell, comparing that value with the maximum volumetric uptake considering the measured density of crystals. From this selection of commercial MOFs, the materials HKUST-1, PCN-250(Fe), MOF-177, and MOF-5 show true potential to fulfill a volumetric requirement of 40 g·L−1 on a material basis for hydrogen storage systems without further packing of the powders.

High surface area microporous carbon materials for cryogenic hydrogen storage synthesized using new template-based and activation-based approaches

HYDROGEN ADSORPTION IN ORDERED MESOPOROUS CARBON SYNTHESIZED BY A SOFT-TEMPLATE APPROACH

Pine Sawdust Derived Ultra-High Specific Surface Area Activated Carbon: Towards High-Performance Hydrogen Storage and Supercapacitors

Large Surface Area Ordered Porous Carbons Via Nanocasting Zeolite 10X and High Performance for Hydrogen Storage Application.

Preparation of sulfur-doped microporous carbons for the storage of hydrogen and carbon dioxide

Ordered Micro-Porous Carbon Molecular Sieves Containing Well-Dispersed Platinum Nanoparticles for Hydrogen Storage

Physically activated resorcinol-formaldehyde derived carbon aerogels for enhanced hydrogen storage

Nanoporous adsorbents for hydrogen storage

Optimization of biomass-based carbon materials for hydrogen storage

Revealing the critical pore size for hydrogen storage via simultaneous enclathration and physisorption in activated carbon

Nitrogen-doped Porous Carbons with High Performance for Hydrogen Storage

Hydrogen Adsorption of Open-Tipped Insufficiently Graphitized Multiwalled Carbon Nanotubes

Hydrogen adsorption on microporous materials at ambient temperatures and pressures up to 50 MPa

Characterization of Carbon Materials for Hydrogen Storage and Compression

High Hydrogen Storage in Trigonal Prismatic Monomer-Based Highly Porous Aromatic Frameworks

Experimental Volumetric Hydrogen Uptake Determination at 77 K of Commercially Available Metal-Organic Framework Materials

Agarose Derived Carbon Based Nanocomposite for Hydrogen Storage at Near-Ambient Conditions

From metal-organic framework to nanoporous carbon: toward a very high surface area and hydrogen uptake.

Screening Study of Different Carbon-Based Materials for Hydrogen Storage

Pore Structure And Hydrogen Storage Of Carbon Nanotubes

Solution-phase Synthesis of Heteroatom-Substituted Carbon Scaffolds for Hydrogen Storage.