Abstract:Computationally inexpensive reduced order models such as Chemical Reactor Networks (CRN) are encouraging tools to obtain fast numerical solutions. However, the accuracy of such models is usually compromised compared to experiments or high-fidelity numerical simulations. Therefore, continued improvement of such models is necessary to ensure reasonable accuracy and fill the need for computationally inexpensive tools. To that end, inputs from computational fluid dynamics simulations have been used to build CRNs in the last 25 years. This can be further improved by the application of data-driven techniques. The present work uses a novel data-driven analysis based on high-fidelity simulation results where the high-dimensional data is first reduced to a low-dimensional manifold and is then clustered into chemically coherent regions. These results along with the high-fidelity simulation results are used to construct a CRN for wet combustion simulations. Wet combustion is a novel clean combustion technique, where an increase in the level of steam dilution distributes the flame, with a risk for flame extinction. This phenomenon, i.e., humid blowout (HBO), was modelled using the above-mentioned CRN. The HBO predicted by the CRN was also tested for thermal power, equivalence ratio, and fuel conditions different from its design point. The error in HBO prediction was quantified by comparing the steam-dilution level at HBO obtained using CRN and that obtained experimentally. The CRN predicted the HBO with an error magnitude less than 5% when the thermal power was unchanged. The maximum error in all tested conditions was 16.65%. Furthermore, a sensitivity analysis revealed that the inclusion of hot gas recirculation through the central recirculation zone, quantified by the mass flow split between the post-flame region and the CRZ, is important in the prediction of HBO, although its accuracy is inconsequential.

Controllability analysis and optimal control of biomass drying with reduced order models

Optimal Control Structure Selection Based on Economics for Continuous Cross-Flow Grain Dryer

An observer for partially obstructed wood particles in industrial drying processes

Study on Modeling and Intelligent Control of Wort Evaporating Process

On-line evaluation of moisture transfer properties for a feed-forward control of a wood drying kiln with a mechanistic model

The simulation and experimental analysis for pneumatic drying of biomass stalk.

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

A Mathematical Framework for Spatio-Temporal Control in Industrial Drying

Control-oriented modeling of direct-heat co-current rotary dryers for energy demand flexibility

Convective drying of wood chips: Accelerating coupled DEM-CFD simulations with parametrized reduced single particle models

Mathematical modelling of heat and mass transfer in agricultural grain drying

SIMULATION OF BIOMASS DRYING IN A DIRECT CONTACT ROTARY DRYER

Modelling Wooden Biomass Combustion in an Vertical Experimental Furnace

Exergy analysis and optimisation of an industrial-scale circulation counter-flow paddy drying process

Computational Fluid Dynamics Study of Biomass Moisture Content Impact on Particle Matter Emissions

Simulation Analysis of Biomass Pyrolysis Based on the Improved Chemical Percolation Devolatilization Model with Chain Reaction Dynamics

A novel data-driven reduced order modelling methodology for simulation of humid blowout in wet combustion applications

Design Of An Intelligent Fuzzy Control System For Biomass Drying Process

Modeling and Simulation of Biomass Air-Steam Gasification in a Fluidized Bed

Multiscale CFD Modeling of High-Temperature Biomass Pyrolysis with an Intraparticle Particle Model and Detailed Pyrolysis Kinetics

Numerical Simulation and Analysis of Pneumatic Drying on Straw Fuel