A general Lewis acidic etching route for preparing MXenes with enhanced electrochemical performance in non-aqueous electrolyte

Youbing Li,Hui Shao,Zifeng Lin,Jun Lu,Per O. A. Persson,Per Eklund,Lars Hultman,Mian Li,Ke Chen,Xian-Hu Zha,Shiyu Du,Patrick Rozier,Zhifang Chai,Encarnacion Raymundo-Piñero,Pierre-Louis Taberna,Patrice Simon,Qing Huang

DOI: https://doi.org/10.48550/arXiv.1909.13236

2019-09-29

Abstract:Two-dimensional carbides and nitrides of transition metals, known as MXenes, are a fast-growing family of 2D materials that draw attention as energy storage materials. So far, MXenes are mainly prepared from Al-containing MAX phases (where A = Al) by Al dissolution in F-containing solution, but most other MAX phases have not been explored. Here, a redox-controlled A-site-etching of MAX phases in Lewis acidic melts is proposed and validated by the synthesis of various MXenes from unconventional MAX phase precursors with A elements Si, Zn, and Ga. A negative electrode of Ti3C2 MXene material obtained through this molten salt synthesis method delivers a Li+ storage capacity up to 738 C g-1 (205 mAh g-1) with high-rate performance and pseudocapacitive-like electrochemical signature in 1M LiPF6 carbonate-based electrolyte. MXene prepared from this molten salt synthesis route offer opportunities as high-rate negative electrode material for electrochemical energy storage applications.

Applied Physics,Materials Science

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to develop a general and effective synthesis method for preparing MXene materials with enhanced electrochemical properties, especially in non - aqueous solvent electrolytes. Specifically, the paper proposes a method of synthesizing MXene through Lewis - acidic molten - salt etching, which can:

1. **Expand the selection range of precursors**: Traditional MXene synthesis methods mainly rely on the selective etching of Al - containing MAX phases in fluorine - containing solutions, which limits the types of precursors that can be used. The method proposed in the paper can etch MAX phases containing different A elements (such as Si, Zn, Ga, etc.) by using different Lewis - acidic molten salts, thereby expanding the synthesis range of MXene.

2. **Improve the electrochemical properties of MXene**: The MXene prepared by this new etching method exhibits excellent electrochemical properties in non - aqueous solvent electrolytes, including high lithium - ion storage capacity, high - rate performance and pseudocapacitance characteristics. For example, the Ti₃C₂ MXene anode material prepared by the CuCl₂ molten - salt method can reach a lithium - ion storage capacity of 738 C g⁻¹ (205 mAh g⁻¹) in a 1M LiPF₆ carbonate - based electrolyte and has excellent rate performance.

3. **Provide a safer synthesis route**: Traditional methods usually require the use of toxic hydrofluoric acid (HF) solutions, while the method proposed in the paper uses Lewis - acidic molten salts, which are relatively safer.

In summary, the goal of the paper is to develop a new etching method that can not only synthesize a wider range of MXene materials, but also significantly improve the electrochemical properties of these materials in non - aqueous solvent electrolytes, thereby providing new material choices for high - performance energy - storage devices (such as lithium batteries and lithium - ion capacitors).