Abstract:In recent years, the installation of underfloor heating systems has increased considerably in many countries, due to their ability to be connected to a solar thermal collector in order to benefit from clean and renewable energy. This promising technology allows for reduced energy consumption, achieves a higher level of comfort, and ensures a more homogeneous temperature distribution than conventional heating systems. A huge loophole is detected in research works concerning the three-dimensional numerical modelling of the thermal behavior of underfloor heating by COMSOL Multiphysics software. The present study aims to reduce these knowledge gaps and to analyze the thermal behavior of the direct solar floor numerically and experimentally under the specific climatic conditions of Casablanca, Morocco. Visualize the thermal behavior of the underfloor heating system and the heating circuit as a 3D model using COMSOL Multiphysics software, based on the finite element method by investigating the influence of various design and operational parameters to select the best parameters that guarantee thermal comfort in the case of installing this heating system in traditional bathrooms. The results obtained by numerical simulation are then compared with those of the experimental measurements in order to verify the validity of the numerical model. The average deviation between the simulated and measured surface temperatures is approximately 1.04%, while the deviation in pipe temperature is around 3.13%, which shows a very good agreement between the numerical and experimental results. In addition, the results of the parametric study indicate that the key elements for enhancing the floor heating system are primarily a floor covered by tile with a minimum thickness of 5 mm, a pipe spacing of approximately 15 cm, a PER pipe diameter of 16/20 mm, and a thermal insulation layer with a thickness of 50 mm made of XPS or polystyrene. The incorporation of these improvements in the standard model ensures a surface temperature within the thermal comfort range of a less warm bathroom, approximately 34.13 °C, and a high heat flux emitted at the surface around 502.07 W compared to the standard model. In the literature, it was found that the comparison of architectural characteristics of direct solar floors receives minimal attention, with most studies only comparing systems in terms of thermal comfort or energy efficiency. In this study, the analysis and interpretation of the results obtained can be used to help engineers and designers select the type and dimensions of the best materials for heating floors installed in traditional bathrooms in Morocco.

An efficient numerical method for a long-term simulation of heat and mass transfer: the case of an insulated rammed earth wall

Numerical Study On Energy Consumption Characteristics For Wall Insulation Structure In Hot Summer And Cold Winter Zone

Numerical Study on Wall Insulation Construction Affecting the Energy Consumption under the Intermittent and Loculose Energy Use

Numerical investigation of the thermal behaviour of external multilayer walls to ensure the buildings retrofitting thermal insulation

Numerical and experimental analysis of building walls thermal performance

Comparison of Old and New Stable Explicit Methods for Heat Conduction, Convection, and Radiation in an Insulated Wall with Thermal Bridging

An innovative method to determine optimum insulation thickness based on non-uniform adaptive moving grid

Stochastic Finite Element Method for Modelling Heat Transfer in the Building Envelope

Implicit Method for Solving Building Heat Transfer Model and Its Application in Energy-Saving Materials

Acceleration of state–space method based on parallelization for enhancing building thermal process simulation efficiency

Simulation of phase change materials in building walls using effective heat capacity model by recent numerical methods

Steady- and Transient-State CFD Simulations of a Modified Barra–Costantini Solar System in Comparison with a Traditional Trombe–Michel Wall

Numerical study and experimental validation of heat transfer in a CenoPCM reinforced multi-layered meta-material wall for energy efficient buildings

Average reduced model to simulate solutions for heat and mass transfer through porous material

Experimental study and numerical simulation of a floor heating system in a three-dimensional model: Parametric study and improvement

Assessment of hygrothermal performance of raw earth envelope at overall building scale

Theoretical Analysis of a Novel Rock Wall to Limit Heating Demands in Historical Buildings

Numerical simulation and sensitivity analysis of lattice passive solar heating walls

3D Numerical Simulation of the Transient Thermal Behavior of a Simplified Building Envelope Under External Flow

Fast Simulation of Dynamic Heat Transfer Through Building Envelope Via Model Order Reduction

An efficient two-dimensional heat transfer model for building envelopes