Low RF power plasma ignition and detection for in-situ cleaning of 1.3 GHz 9-cell cavities

P. Berrutti,B. Giaccone,M. Martinello,A. Grassellino,T. Khabiboulline,M. Doleans,S. Kim,D. Gonnella,G. Lanza,M. Ross
DOI: https://doi.org/10.1063/1.5092235
2019-02-09
Abstract:Superconducting Radio Frequency (SRF) cavities performance preservation is crucial, from vertical test to accelerator operation. Field Emission (FE) is still one of the performance limiting factors to overcome and plasma cleaning has been proven successful by the Spallation Neutron Source (SNS), in cleaning field emitters and increasing the work function of Nb. A collaboration has been established between Fermi National Accelerator Laboratory (FNAL), SLAC National Accelerator Laboratory and Oak Ridge National Laboratory (ORNL) with the purpose of applying plasma processing to the Linac Coherent Light Source-II (LCLS-II) cavities, in order to minimize and overcome field emission without affecting the high Q of nitrogen-doped cavities. The cleaning for LCLS-II will follow the same plasma composition adopted at SNS, which allows in-situ processing of cavities installed in cryomodules from hydrocarbon contaminants. A novel method for plasma ignition has been developed at FNAL: a plasma glow discharge is ignited using high order modes to overcome limitations imposed by the fundamental power coupler, allowing in-situ cleaning for cavities in cryomodule. The plasma can be easily ignited and tuned in each of the cavity cells using low RF power. A method for plasma detection has been developed as well, which allows the detection of the plasma location in the cavity without the need of cameras at both cavity ends. The presented method can be applied to other multi-cell cavity designs, even for accelerators where the coupling for the fundamental modes at room temperature is very weak.
Accelerator Physics,Plasma Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the key issue of performance maintenance of superconducting radio - frequency (SRF) cavities during the process from vertical testing to accelerator operation, especially the limiting factor of field emission (FE). As mentioned in the paper, plasma cleaning technology has been proven to be able to effectively clean field emitters and increase the work function of niobium (Nb), thereby overcoming the field emission problem. The main objective of the research is to minimize and overcome the field emission problem without damaging the high - Q nitrogen - doped cavities for cavity cleaning in Linac Coherent Light Source - II (LCLS - II). Specifically, the paper focuses on developing a new method for low - radio - frequency (RF) power plasma ignition and detection for in - situ cleaning of 1.3 GHz 9 - cell cavities. This method utilizes high - order modes (HOMs) to ignite plasma glow discharge, which overcomes the limitations brought by the fundamental power coupler, enabling in - situ cleaning of cavities even in cryomodules. In addition, a plasma detection method has been developed, which can determine the position of the plasma without using cameras at both ends of the cavity. The paper experimentally verifies the effectiveness of these methods and explores the plasma ignition curves under different gases (such as neon and argon) and pressures, as well as the required electric fields and radio - frequency voltages. These studies are of great significance for optimizing parameters such as forward power, pressure, and gas type. At the same time, the paper also discusses plasma tuning measurements as a means of controlling plasma density.