Abstract:Hydrogen production from ethanol reforming using microwave plasmas has great potential. In this study, a microwave plasma torch is used as a plasma source. Air is used as a discharge gas to generate the plasma. Ethanol and air are mixed and injected directly into the plasma reaction zone in a vortex flow. The effects of the oxygen-to-ethanol molar ratio (O2/Et), ethanol flow rate, and absorbed microwave power on the reforming results are investigated. When the O2/Et exceeds 0.9, ethanol is completely converted. The hydrogen selectivity is the largest when the O2/Et is 1.1, which is about 66.5%. The maximum hydrogen production rate is 2.19 mol(H2)/mol(C2H5OH). The best carrier gas residence time is 0.64-0.81 s. An appropriate increase in the ethanol flow rate can improve the ethanol conversion rate and energy efficiency while reducing the hydrogen selectivity and hydrogen yield, so the ethanol flow rate should not exceed 42.1 mL/min. The cost of hydrogen production is minimum [$3.66/kg(H2)] when the ethanol flow rate is 42.1 mL/min. The positive effect of the absorbed microwave power on the reforming reaction is significant, but too much microwave power also reduces energy efficiency. The optimum experimental conditions are an O2/Et of 0.9, an ethanol flow rate of 42.1 mL/min, and an absorbed microwave power of 700 W. The maximum energy yield is 861.91 NL(H2)/kWh at an absorbed microwave power of 700 W. The main reforming products are H2, CO, CO2, CH4, C2H2, C2H4, C2H6, C3H6, C3H8, C4H10n, and C4H10i. The content of C2 or higher hydrocarbons is considerably low. Almost no deposited carbon is generated in the experiment, which means that the design of the reforming system is effective in suppressing carbon deposition.

Production of hydrogen-rich gas from methane by thermal plasma reform

The Characteristics of Sorption Enhanced Steam Methane Reforming for Hydrogen Production on a Complex Catalyst

Progress on Reforming of Carbon Dioxide and Methane to Synthesis Gas by Thermal Plasma

Carbon Dioxide Reforming of Methane to Syngas by Thermal Plasma

Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma

Production of pure hydrogen from methane by low temperature plasma processing

Biogas Reforming for Hydrogen-Rich Syngas Production over a Ni–K/Al2O3 Catalyst Using a Temperature-Controlled Plasma Reactor

Reforming of Methane and Carbon Dioxide by DC Water Plasma at Atmospheric Pressure

Hydrogen Production from Ethanol Reforming by a Microwave Discharge Using Air as a Working Gas

Warm plasma catalytic coreforming of dilute bioethanol and methane for hydrogen production

Reforming of CH4 and CO2 by Combination of Alternating Current-Driven Nonthermal Arc Plasma and Catalyst

Hydrogen-rich gas production from tar model compound disintegrates over low-temperature plasma in dielectric barrier discharge reactor

Syngas Production from Propane Using Atmospheric Non-thermal Plasma

Hydrogen-Rich Syngas Production via Dry and Steam Reforming of Methane in Simulated Producer Gas over ZSM-5-Supported Trimetallic Catalysts

GLIDING ARC DISCHARGE PLASMA ASSISTED REFORMING OF METHANE INTO HYDROGEN WITH OXYGEN AND WATER VAPOR

Enhanced hydrogen production using a tandem biomass pyrolysis and plasma reforming process

Plasma Activation of Methane for Hydrogen Production in a N2 Rotating Gliding Arc Warm Plasma: A Chemical Kinetics Study

Hydrogen Production From Partial Oxidation Of Methane Using An Ac Rotating Gliding Arc Reactor

Feasibility of a Plasma Furnace for Methane Pyrolysis: Hydrogen and Carbon Production

Bi-reforming of Methane in a Carbon Deposit-Free Plasmatron with High Operational Adaptability

Hydrogen-rich gas production from biomass steam gasification in an updraft fixed-bed gasifier combined with a porous ceramic reformer