Abstract:In this paper, we investigate the time–temperature correlation of amorphous thermoplastics at large strains based on coarse-grained molecular dynamics simulations. This correlation behavior is characterized by the strain hardening modulus in uniaxial tension simulations at different strain rates across the glass transition region. The temperature regime is divided into a melt zone, a glassy zone, and a transition zone between them, according to the storage modulus calculated from dynamic mechanical analysis (DMA) at small strains. In the melt zone, the existence of time–temperature superposition (TTS) at large strains is verified by constructing a master curve of the hardening modulus. The obtained shift factors are then compared to those from DMA at small strains, showing that the TTS behavior is transferable between small and large strains. In the glassy zone, the effects of time and temperature are not superposable at large strains but still can be correlated. To demonstrate this correlation behavior, we introduce a level set of the hardening modulus with a variable pair of strain rate and temperature. Pairs lying in the same level result in coincident stress–strain curves at large strains. The transferability of the correlation behavior between large and small strains is validated by comparing these stress–strain curves at small strains in the pre-yield region. In the transition zone, the correlation behavior is studied with both aforementioned methods, showing that TTS is applicable to large strains but not transferable to small strains. Finally, we propose a phenomenological constitutive model for uniaxial tension to demonstrate the time–temperature correlation at large strains, considering different constant strain rates and temperatures.

Thermodynamic relations among isotropic material properties in conditions of plane shear stress

Interpretation of Torsional Shear Results for Nonlinear Stress–strain Relationship

Time-dependent Behavior of Axisymmetric Thermal Consolidation for Multilayered Transversely Isotropic Poroelastic Material

Three-dimensional Thermo-Hydro-mechanical Responses of Stratified Saturated Porothermoelastic Material

Plane strain and three-dimensional analyses for thermo-mechanical behavior of multilayered transversely isotropic materials

77 New Thermodynamic Identities among Crystalline Elastic Material Properties Leading to a Shear Modulus Constitutive Law in Isotropic Solids

Time–temperature Correlations of Amorphous Thermoplastics at Large Strains Based on Molecular Dynamics Simulations

Effective thermodynamic potentials and internal variables: Particulate thermoviscoelastic composites

Problems associated with the contrast between thermal and mechanical properties of materials

Thermodynamic Relationships for Perfectly Elastic Solids Undergoing Steady-State Heat Flow

2D Quasi-Static Accurate Solutions for Isotropic Thermoelastic Materials with Applications

Effective thermodynamic potentials and internal variables: Linear viscoelastic composites

Effect of shear flow on the transverse thermal conductivity of polymer melts

Universality of the angled shear wave identity in soft viscous solids

Stress and strain fields near cracks in solids with stress state-dependent elastic properties under conditions of anti-plane shear

Generic elasticity of thermal, under-constrained systems

Thermodynamics of coherent interfaces under mechanical stresses. I. Theory

Correspondence Relations Between the Effective Thermoelastic Properties of Composites Reinforced by Spherically Anisotropic Particles

Thermodynamics and analysis of rate-independent adhesive contact at small strains