Abstract:With the downscaling of CMOS devices, dynamic variability induced by negative bias temperature instability (NBTI) has become a critical issue. In addition to the time-dependent device-to-device variation (DDV) of NBTI degradation, the cycle-to-cycle variation (CCV) originated from random trap occupation is found non-negligible and should be added into the total dynamic variation. This paper summarizes our recent studies on NBTI-induced dynamic variability, focusing on the CCV effect, with more details on the statistical modeling, circuit reliability simulation methodologies and experimental results. By adding the random trap occupation into consideration, a statistical model for total dynamic variation (DDV+CCV) is proposed. The effective occupancy probability peff is introduced as a key parameter for modeling and circuit reliability simulation. With the statistical trap response (STR) method and modified on-the-fly method, the proposed model is validated by the experimental evidence under both DC and AC NBTI. According to the model and experimental results, circuit reliability simulation framework is proposed for both long-term quasi-static and short-term transient performance evaluation with the additional impact of CCV. Two representative digital circuit units, ring oscillator (RO) and SRAM cell, are simulated under different conditions, indicating it necessary to consider the evident influence of the CCV in accurate circuit reliability evaluation. The results are helpful for the reliability/variability-aware circuit design in nanoscale technology.

Experimental metrics for detection of detailed balance violation

Violation of detailed balance in microwave circuits: theory and experiment

Signals of detailed balance violation in nonequilibrium stationary states: Subtle, manifest, and extraordinary

Nonperturbative Leakage Elimination Operators and Control of a Three-Level System

A generalized cycle benchmarking algorithm for characterizing mid-circuit measurements

Modeling low- and high-frequency noise in transmon qubits with resource-efficient measurement

Pauli Noise Learning for Mid-Circuit Measurements

Mass Measurement Method for the Electronic Balance Based on Continuous-Time Sigma-Delta Modulator

Influence of noise on Josephson junctions dynamics with a BCS theory-based model

Measurement-driven Quality Assessment of Nonlinear Systems by Exponential Replacement

Conditional statistics of electron transport in interacting nanoscale conductors

Nonequilibrium Steady State Full Counting Statistics in the Noncrossing Approximation

Robust Noise Suppression and Quantum Sensing by Continuous Phased Dynamical Decoupling

Proposed real-time charge noise measurement via valley state reflectometry

Measuring error rates of mid-circuit measurements

Weak Measurement of Qubit Oscillations with Strong Response Detectors: Violation of the Fundamental Bound Imposed on Linear Detectors

Investigation on NBTI-induced dynamic variability in nanoscale CMOS devices: Modeling, experimental evidence, and impact on circuits.

Randomized Benchmarking Protocol for Dynamic Circuits

Sensing quantum vacuum fluctuations with non-Gaussian electronic noise

Measurement principle of tuned balance method for partial discharge