Abstract:Abstract Automotive engine downsizing has placed an increased focus on the ability of the turbocharger to provide adequate boost levels across the full engine operating rage. To achieve the desired levels of turbocharger performance the turbine must be capable of operating effectively at the intended design point and also at off-design conditions. Mixed flow turbines (MFTs) provide a potential method to improve performance at off-design conditions and during transient engine operation. A unique feature of a MFT is the spanwise variation of incidence angle at the rotor leading edge. This results in additional flow separation from the blade suction surface near the hub under a wide range of operating conditions. The flow separation generates additional loss and has a detrimental impact on turbine performance. A novel design of turbine volute similar to a conventional twin-entry turbine volute was examined. The novel turbine volutes were designed to produce a spanwise variation in flow conditions at the rotor inlet. The primary objective was to reduce the incidence angle and increase the mass flow rate at the hub side of the passage relative to the shroud side, as it has previously been identified that this can be beneficial for MFT performance. A number of different volute geometries were examined by numerical analysis to determine the impact of key parameters on turbine performance. The results indicated that generating a suitable spanwise flow distribution could produce a moderate improvement in turbine efficiency at off-design operating conditions. The novel volute design also provided a means of achieving a degree of variable geometry operation to further improve off-design performance. Turbine performance was examined under the variable geometry operation and an improvement in turbine power output at low speed, off-design conditions was achieved. This was analogous to operating with a conventional pivoting vane variable geometry system and had the potential to benefit performance during transient engine operation.

Cyclonic dirt separator turbine accelerator

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Cyclone separator for fluid media

Centrifugal compressor with inlet guide blades and turbocharger

Centrifugal compressor having air removal jet box structure

Investigation of a Novel Turbine Housing to Produce a Non-Uniform Spanwise Flow Field at the Inlet to a Mixed Flow Turbine and Provide Variable Geometry Capabilities

Blade forward-swept centrifugal compressor and turbocharger

Industrial Gas Turbine Performance: Compressor Fouling and On-Line Washing

Propulsion engine has variable cycle for supersonic aircraft.

Experimental Study on Velocity Field Between Two Adjacent Blades and Gas–solid Separation of a Turbo Air Classifier

Compressor using asymmetrical bladed diffuser with variable mounting angles and consistency coupling

Asymmetrical self-circulating casing treatment for centrifugal compressor based on Variable slot positions

High durability variable geometry turbine for commercial vehicle turbochargers

Wet-type whirlwind dust collector

Optimized Design of the Volute Between Turbine and Regenerator in Micro Gas Turbine

Improving Purge Air Cooling Effectiveness by Engineered End-Wall Surface Structures-Part II: Turbine Cascade

Centrifugal compressor using asymmetrical bladed diffuser with variable mounting angles in circumferential direction

Film Cooling Modeling in a Turbine Working under the Unsteady Exhaust Flow of Pulsed Detonation Combustion

Design and Simulation of Supersonic Swirling Separator

Active Flow Control for Passage Vortex Reduction in a Linear Turbine Cascade with Various Tip Clearance Sizes Using a Dielectric Barrier Discharge Plasma Actuator

Separation flow control and engineering application of synthetic jets in compressor