Abstract:This work reports an approach to study complementary pairs of bipolar junction transistors, often used in push-pull circuits typically found at the output stages of operational amplifiers. After the data is acquired and pre-processed, an Early modeling approach is applied to estimate the two respective parameters (the Early voltage $V_a$ and the proportionality parameter $s$). A voting procedure, inspired on the Hough transform image analysis method, is adopted to improve the identification of $V_a$. Analytical relationships are derived between the traditional parameters current gain ($\beta$) and output resistance ($R_o$) and the two Early parameters. It is shown that $\beta$ tends to increase with $s$ for fixed $V_a$, while $R_o$ depends only on $V_a$, varying linearly with this parameter. Several interesting results are obtained with respect to 7 pairs of complementary BJTs, each represented by 10 samples. First, we have that the considered BJTs occupy a restricted band along the Early parameter space, and also that the NPN and PNP groups are mostly segregated into two respective regions in this space. In addition, PNP devices tended to present an intrinsically larger parameter variation. The NPN group tended to have higher $V_a$ magnitude and smaller $s$ than PNP devices. NPN transistors yielded comparable $\beta$ and larger $R_o$ than PNP transistors. A pattern recognition method was employed to obtain a linear separatrix between the NPN and PNP groups in the Early space and the respective average parameters were used to estimate respective prototype devices. Two complementary pairs of the real-world BJTs with large and small parameters differences were used in three configurations of push pull circuits, and the respective total harmonic distortions were measured and discussed, indicating a definite influence of parameter matching on the results.

An Early Modeling Approach to Digital Electronics

An Early Model of Transistors and Circuits

Characterizing Complementary Bipolar Junction Transistors by Early Modelling, Image Analysis, and Pattern Recognition

Transient current responses of organic electrochemical transistors: Evaluating ion diffusion, chemical capacitance, and series elements

A Coupled 3D Finite Element-Circuit Model for the Numerical Analysis of Small Time Scale Transients of an Insulated Gate Bipolar Transistor Power Electronics Device

Piecewise-linear timing delay modeling for digital CMOS circuits

Understanding Asymmetric Switching Times in Accumulation Mode Organic Electrochemical Transistors

Loss Measurement of Low RDS Devices Through Thermal Modelling - The Advantage of Not Turning it Fully On

Modeling of CMOS Transistors from 0.18 Μm Process by Artificial Neural Network

A Microwave Modeling Oxymoron?: Low-Frequency Measurements for Microwave Device Modeling

Circuit-Level Delay Modeling Considering Both Tddb And Nbti

Simulating Organic Thin Film Transistors Using Multilayer Perceptron Regression Models to Enable Circuit Design

Design of a compact MOSFET model suitable for geometric programming

Benchmarking contact quality in N-type organic thin film transistors through an improved virtual-source emission-diffusion model

A model and implementation of a universal time delay simulator for large digital nets

Sub-1 Ns Characterization Methodology for Transistor Electrical Parameter Extraction

A Procedure for Characterizing the BJT Base Resistance and Early Voltages Utilizing a Dual Base Transistor Test Structure

Artificial neural network design for compact modeling of generic transistors

Accurate modeling and parameter extraction for MOS transistors valid up to 10 GHz

Transistor Compact Model Based on Multigradient Neural Network and Its Application in SPICE Circuit Simulations for Gate-All-Around Si Cold Source FETs

A High-Frequency MOS Transistor Model and its Effects on Radio-Frequency Circuits