Abstract:This work describes a novel finite strain hypo-elastic formulation for amorphous thermoset polymers working in the glassy regime. The constitutive formulation is able to describe time and pressure-dependent behaviour under loading rates ranging from quasi-static to impact-type loading conditions and to account for thermo-mechanical coupling effects. A non-linear pressure dependent potential function is introduced to capture the non-associative visco-plastic potential flow for volumetric plastic strain control. The formulation also incorporates an internal state or deformation resistance variable to enable the description of the polymer hardening - softening behaviour, as well as a novel relation for the dissipative fraction of the plastic work in terms of the equivalent accumulated plastic strain. The constitutive model is formulated within a finite strain kinematics framework, and full details of its numerical implementation into the finite element method using a fully implicit Euler Backward algorithm are given. Model calibration is carried out for three different thermosetting resins (PR520 and RTM6 Epoxies, and MMA adhesives).To illustrate the model capabilities, two case studies are investigated: (i) the de-formation behaviour of epoxy under moderate and impact-type loading conditions under isothermal and fully adiabatic conditions, and (ii) the fracture behaviour of adhesive layers used to bond stiff metallic substrates. Results on RTM6 epoxy show that at, e.g., 60% true strain, 48.5% of the rate of plastic work is dissipative, and that the corresponding predicted increase in temperature due to the locally dissipated heat is consistent with published calorimetry data on a similar thermoset polymer. It was also found that, by coupling the proposed constitutive model with a cohesive zone model, it was possible to predict accurately the effect of an MMA adhesive layer thickness and pressure-dependency on the growth of an interfacial crack between the MMA adhesive and the metallic substrates. The proposed model should constitute a generic phenomenological formulation for the mechanical behaviour prediction of a wide range of thermoset polymers under confined and quasi-adiabatic conditions such as in composites and adhesive joints.

The Role of Adhesion in the Mechanics of Crumpled Polymer Films

Unique Aspects of a Shape Memory Polymer As the Substrate for Surface Wrinkling.

Crumples as a generic stress-focusing instability in confined sheets

The Mullins effect in the wrinkling behavior of highly stretched thin films

Surface effects on the wrinkles in a stiff thin film bonded to a compliant substrate

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. Part Iii: Influence of Morphology on Molecular Orientation of Isotactic Polypropylene Films Subjected to Uniaxial Stretching

Finite Deformation Mechanics In Buckled Thin Films On Compliant Supports

Dewetting of Polymer Films with Built-In Topographical Defects

Confinement-Induced Stiffening of Elastomer Thin Films

Surface Stress and Surface Tension in Polymeric Networks

Effect of Triaxial Stress Constraint on the Deformation and Fracture of Polymers

Wrinkle, fold, and ridge patterns of thin films attached to a compliant substrate: Direct numerical simulations involving plastic yielding

Crumpling of a stiff tethered membrane

Deformation of polymer films by bending forces

The friction and deformation of polymers

Mechanical behavior of thin films due to in-plane tensile and fatigue loadings

A Finite Deformation Formulation for Amorphous Glassy Polymers under Moderate and Impact Strain Rates: Application to Adhesive Films

Stretch-induced wrinkling of highly orthotropic thin films

Mechanics of Tension-Induced Film Wrinkling and Restabilization: a Review

Numerical Analysis on the Wrinkling Instability of a Stiff Film Adhering to an Elastic Substrate with a Graded Coating

Deformation Mechanism of Conjugated Polymer Films During Single and Cyclic Stretching