Abstract:Nonlinear buckling of elastic thin films on compliant substrates is studied by modeling and simulations to reveal the roles of pre-strain, elastic modulus ratio, and interfacial properties in morphological transition from wrinkles to buckle-delamination blisters. The model integrates an interfacial cohesive zone model with the Föppl–von Kármán plate theory and Green function method within the general framework of energy minimization. A kinetics approach is developed for numerical simulations. Subject to a uniaxial pre-strain, the numerical simulations confirm the analytically predicted critical conditions for onset of wrinkling and wrinkle-induced delamination, with which a phase diagram is constructed. It is found that, with increasing pre-strain, the equilibrium configuration evolves from flat to wrinkles, to concomitant wrinkles and buckle-delamination, and to an array of parallel straight blisters. The height and width of the buckle-delamination blisters can be approximately described by a set of scaling laws with respect to the pre-strain and interfacial toughness. Subject to an equi-biaxial pre-strain, the critical conditions are determined numerically to construct a similar phase diagram for the buckling modes. Moreover, by varying the pre-strain, modulus ratio, and interfacial toughness, a rich variety of equilibrium configurations are simulated, including straight blisters, and network blisters with or without wrinkles. These results provide considerable insight into diverse surface patterns in layered material systems as a result of the mechanical interactions between the film and the substrate through their interface, which suggests potential control parameters for designing specific surface patterns.

Wrinkle, fold, and ridge patterns of thin films attached to a compliant substrate: Direct numerical simulations involving plastic yielding

Spatially Configuring Wrinkle Pattern and Multiscale Surface Evolution with Structural Confinement

Surface effects on the wrinkles in a stiff thin film bonded to a compliant substrate

Instabilities of Thin Films on a Compliant Substrate: Direct Numerical Simulations from Surface Wrinkling to Global Buckling

Wrinkling of Thin Films on a Microstructured Substrate

Surface Wrinkling Patterns of Film–Substrate Systems with a Structured Interface

Coexistence and Coevolution of Wrinkle and Ridge Patterns in the Film-Substrate System by Uniaxial Compression.

Surface Wrinkling of Nanostructured Thin Films on a Compliant Substrate

Effect of Lateral Dimension on the Surface Wrinkling of a Thin Film on Compliant Substrate Induced by Differential Growth/swelling

Nonlinear Analysis of Compressed Elastic Thin Films on Elastic Substrates: from Wrinkling to Buckle-Delamination

Localization of Wrinkle Patterns by Crack-Tip Induced Plasticity: Experiments and Simulations

Finite Deformation Mechanics In Buckled Thin Films On Compliant Supports

Surface Wrinkling of Anisotropic Films Bonded on a Compliant Substrate

Effects of Tension–compression Asymmetry on the Surface Wrinkling of Film–substrate Systems

Analysis of Experimental Biaxial Surface Wrinkling Pattern Based on Direct 3D Numerical Simulation

Mechanics of wrinkling of a thin film bonded to a compliant substrate under the influence of spatial thermal modulation

Towards a Quantitative Understanding of Period-Doubling Wrinkling Patterns Occurring in Film/substrate Bilayer Systems.

Quantitative predictions of diverse wrinkling patterns in film/substrate systems

Wrinkling of Twisted Thin Films

Wrinkling and Creasing of A Compressed Elastoplastic Film Resting on A Soft Substrate

Modeling kinetics of diffusion-controlled surface wrinkles.