Lateral constrained wrinkling of the film with partial contact
Mengxiong Liu,Zhiming Xue,Yafei Wang,Xide Li,Changguo Wang
DOI: https://doi.org/10.1016/j.ijmecsci.2021.107022
IF: 7.3
2022-01-01
International Journal of Mechanical Sciences
Abstract:This paper establishes three analytical models, including the interface bonded type (B-type), interface sliding type (S-type) and the lateral constrained type (C-type), to reveal the effects of the partial contact and lateral constraints on the film wrinkling behaviors. Due to the geometrical and contact nonlinearities, a numerical method is applied to solving the displacement and stress fields, and the shear-lag effect caused by contact is included. The deformation of the film can be characterized by 5 processes, firstly compressing (I), secondly wrinkling (II), then the growing of wrinkled part giving rise to point contact (III), line contact (IV), and finally mode transition(V), which are verified by a demonstrative experiment. Moreover, effects of the contact parameters, including the interfacial strength, interfacial stiffness and the initial contact region length, on the deformation of the film are analyzed. Finally, the established models are applied to characterize the wrinkling behaviors of a graphene contacting to the polyethylene terephthalate (PET). The minimum pre-existing defect size for graphene wrinkling is 7 nm, less than which the interface failure precedes the film wrinkling. The critical wrinkling strain shows significant size effect when the graphene length is less than 13 mu m, where all the interfaces participate the load transfer. The obtained results are consistent with the experimental and the numerical data given in the references, where the differences are also discussed detailly.