Abstract:From laboratory and field test results, it is now largely agreed that reducing the overall salinity, especially the concentration of divalent ions of the injected water, can markedly improve the oil recovery. However, as a result of the complexity of the crude oilbrinerock (COBR) system, there is no clear explanation of why the divalent cations (Ca2+) are of major significance in a low-salinity water effect (LSWE). In the present paper, spontaneous imbibition, zeta-potential measurements, static adsorption/desorption of benzoic acid (BA) onto crushed Berea, and BA self-assembled layers on silica wafer have been performed to correlate macroscopic wettability alteration during low-saline water flood with the microscopic release of the hydrophobic layers (organic acid layers) on mineral surfaces and explain the relevance of active cations (Ca2+) in this process, thereby providing a better understanding of the underlying mechanisms of a LSWE. Spontaneous imbibition results show that initial wettability of the COBR system was dominantly controlled by the initial concentration of Ca2+ rather than Na+ in brine; i.e., the initial wettability changed to be more oil-wet with an increasing concentration of CaCl2 in initial water, while changing the concentration of NaCl in initial water had little effect on initial wettability. Moreover, reducing salinity of imbibing brine can outstandingly improve oil recovery of cores aged by CaCl2 brine, whereas no obvious enhanced oil recovery (EOR) by low-salinity water was observed for cores aged by NaCl brine. Decreasing the concentration of either CaCl2 or NaCl brine was able to make the oil/brine and brine/rock interfaces become less positively charged or even more negatively charged, observed by zeta-potential measurements, resulting in increased electrostatic repulsive forces between the oil/brine and brine/rock interfaces. These results suggest that the anionic groups of organic acid from crude oil, such as carboxylate, adsorb onto negatively charged mineral surfaces mainly through calcium bridges instead of van der Waals forces or sodium bridges and reducing salinity is able to increase the electrostatic repulsive forces between mineral surfaces and carboxylate groups and then break calcium bridges to change the wettability of the rock surface to be less oil-wet, and as a result, EOR occurs. These suggestions were supported by the static adsorption/desorption studies and self-assembly experiments. After sorption to crushed Berea, the varied BA concentration in the supernatant analyzed by total organic carbon (TOC) reveals that the presence of the background electrolyte Ca2+ largely enhanced sorption in comparison to Na+. Lowering salinity was able to desorb BA from crushed Berea. Field emission scanning electron microscopy (FESEM) was used to obtain the microchemical composition and morphology of the wafer surface interacted with BA under different ionic strengths and solution cations (Ca2+ and Na+). Ca2+ ions were found to enhance the adsorption of BA self-assembled layers on a silica wafer compared to Na+, which directly demonstrates that BA molecules mainly self-assemble on SiO2 by calcium bridges rather than sodium bridges or van der Waals forces. The BA self-assembled layers were released after immersing organo-wafer into deionized water.

Insights into the nano-structure of oil-brine-kaolinite interfaces: Molecular dynamics and implications for enhanced oil recovery

Surface Wettability of Basal Surfaces of Clay Minerals: Insights from Molecular Dynamics Simulation

Nano Structure of CO2-Brine-Kaolinite Interface: Implications for CO2 Geological Sequestration

Electrostatic Characterization of -Nh+-brine-kaolinite System: Implications for Low Salinity Waterflooding in Sandstone Reservoirs

Molecular Dynamic Simulations of Montmorillonite–Organic Interactions under Varying Salinity: An Insight into Enhanced Oil Recovery

Wettability Alteration and Oil-Water-Rock Interaction at Hydrated Kaolinite Clay Mineral Surfaces

Molecular insights into oil detachment from hydrophobic quartz surfaces in clay-hosted nanopores during steam-surfactant co-injection

Understanding model crude oil component interactions on kaolinite silicate and aluminol surfaces: towards improved understanding of shale oil recovery

Electrostatic Characterization of the −COOH–Brine–Clay System: Implications for Wettability Alteration during Low Salinity Waterflooding in Sandstone Reservoirs

Drivers of Wettability Alteration for Oil/Brine/Kaolinite System: Implications for Hydraulic Fracturing Fluids Uptake in Shale Rocks

Molecular dynamics simulation of surfactant induced wettability alteration of shale reservoirs

Wettability Alteration During Low-Salinity Waterflooding and the Relevance of Divalent Ions in This Process

Simulation of Oil-Water Rock Wettability of Different Constituent Alkanes on Kaolinite Surfaces at the Nanometer Scale

Adsorption behavior of shale oil and water in the kerogen-kaolinite pore by molecular simulations

Nanofluid-Induced Wettability Gradient and Imbibition Enhancement in Natural Porous Media: A Pore-scale Experimental Investigation

Enhancement of Oil Transport Through Nanopores Via Cation Exchange in Thin Brine Films at Rock-Oil Interface

Revealing crucial effects of reservoir environment and hydrocarbon fractions on fluid behaviour in kaolinite pores

Wettability Alteration Induced Water Uptake in Shale Oil Reservoirs: A Geochemical Interpretation for Oil-Brine-om Interaction During Hydraulic Fracturing

Insights into stability of silica nanofluids in brine solution coupled with rock wettability alteration: An enhanced oil recovery study in oil-wet carbonates

Ph Effect on Wettability of –Nh+-Brine-muscovite System: Implications for Low Salinity Effect in Sandstone Reservoirs

Wetting Behavior Of Shale Rocks And Its Relationship To Oil Composition