Abstract:More than half of the discovered hydrocarbon reservoirs in the world are the oil-wet carbonates. Enhanced oil recovery (EOR) from these reservoirs is challenging because of their tendency to retain oil at the rock surface. The use of low salinity (LS) water injection to recover more oil from these types of oil reservoirs has been recommended by several researchers. There are possible mechanisms concerning LS water flooding that have been introduced in the literature; a distinct lack of experimental investigation to enhancing the efficiency of this method is still felt. In this work, a detailed and comprehensive study was carried out on using LS + surfactant (LSS) to improve the surface and interface properties of oil + water + calcite rock samples. In the first step, the point of zero charge of the rock sample was determined. Then, the effect of different salts including MgCl2, CaCl2, and Na2SO4 at different concentrations on improving the oil-water interfacial tension and wettability alteration of the rock surfaces was investigated in the presence and absence of a cationic surfactant, cetyl methylammonium bromide (CTAB), in the operational range of pH. Emulsion formation and adsorption measurement tests were performed for a deep investigation of the performance of the cationic surfactant in the presence of different salts. Finally, waterflooding experiments were carried out and the water/oil relative permeabilities, amount of recovery and wettability alteration were thoroughly investigated for three different injection scenarios. The results showed that the co-presence of magnesium, calcium and sulfate ions all in the presence and absence of CTAB surfactant causes a significant reduction in IFT and contact angle values, especially at the lower ranges of salinity. The addition of divalent cations, i.e., Mg2+ and Ca2+, could reduce the amount of surfactant adsorbed on the calcite rock surfaces, especially in the low ranges of salinities. Also, in flooding tests, an increase in differential pressure between the inlet and outlet faces of the core samples from about 2.9 MPa for LS to about 4.7 MPa for LSS flooding, at the breakthrough time, was observed which was related to the formation of water in oil emulsions during LSS flooding. Comparison of the ratio of the residual to initial oil saturation (Sor/Soi) for different flooding scenarios (i.e., injection of saline water (SW), LS and LSS solutions) indicates that as the salinity of water reduces, the efficiency of CTAB surfactant in improving oil recovery increases.

Molecular dynamics simulation for the effect of cation replacement on the oil-brine-rock interaction

Molecular dynamics study of the effect of inorganic salts on the monolayer of four surfactants at the oil/water interface

Experimental and Molecular Dynamics Simulation to Investigate Oil Adsorption and Detachment from Sandstone/Quartz Surface by Low-Salinity Surfactant Brines

Impacts of inorganic salts ions on the polar components desorption efficiency from tight sandstone: A molecular dynamics simulation and QCM-D study

Enhancement of Oil Transport Through Nanopores Via Cation Exchange in Thin Brine Films at Rock-Oil Interface

Molecular Dynamics Study on the Effects of Metal Cations on Microscale Interfacial Properties of Oil–Water-Surfactant System

Investigation of modified Water chemistry for improved oil recovery: Application of DLVO theory and surface complexation model

A mechanistic experimental study on the combined effect of Mg2+, Ca2+, and SO42- ions and a cationic surfactant in improving the surface properties of oil/water/rock system

Molecular Dynamic Simulations of Montmorillonite–Organic Interactions under Varying Salinity: An Insight into Enhanced Oil Recovery

A comprehensive insight on the impact of individual ions on Engineered Waterflood: With already strongly water-wet sandstone

Insights into mechanism of low salinity water flooding in sandstone reservoir from interfacial features of oil/brine/rock via intermolecular forces

Theoretical and experimental investigation of the impact of oil functional groups on the performance of smart water in clay-rich sandstones

Salinity and pH effects on water-oil-calcite interfaces by using molecular dynamics

Molecular Insights into the Salinity Effects on Movability of Oil-Brine in Shale Nanopore-Throat Systems

Understanding the effects of salinity on bitumen-calcite interactions

Effects of Sulfate Ions on Crude Oil Adsorption/Desorption on Carbonate Rocks: Experimental and Molecular Simulations

Integrated Geochemical Modelling of Low Salinity Waterflooding for Enhanced Oil Recovery in Carbonate Reservoir

Application of Low-Salinity Waterflooding in Heavy Oil Sandstone Reservoir: Oil Recovery Efficiency and Mechanistic Study

Salt-acid-surfactant synergistic effects on interfacial characteristics of water/oil systems: A molecular dynamics simulation study

Ion Valency and Concentration Effect on the Structural and Thermodynamic Properties of Brine-Decane Interfaces with Anionic Surfactant (SDS).

Effect of Electrokinetics and Thermodynamic Equilibrium on Low-Salinity Water Flooding for Enhanced Oil Recovery in Sandstone Reservoirs