Abstract:Although defect engineering is the core strategy to improve thermoelectric properties, there are limited methods to effectively modulate the designed defects. Herein, we demonstrate that a high ZT value of 1.36 at 775 K and a high average ZT value of 0.99 in the temperature range from 300 to 825 K are realized in Zn-containing PbTe by designing complex defects. By combining first-principles calculations and experiments, we show that Zn atoms occupy both Pb sites and interstitial sites in PbTe and couple with each other. The contraction stress induced via substitutional Zn on Pb sites alleviates the swelling stress by Zn atoms occupying the interstitial sites and promotes the solubility of interstitial Zn atoms in the structure of PbTe. The stabilization of Zn impurity as a complex defect extends the region of PbTe phase stability toward Pb0.995Zn0.02Te, while the solid solution region in the other direction of the ternary phase diagram is much smaller. The evolution of defects in PbTe was further explicitly corroborated by aberration-corrected scanning transmission electron microscopy (Cs-corrected STEM) and positron annihilation measurement. The Zn atoms compensate the Pb vacancies (VPb) and Zn interstitials (Zni) significantly improve the electron concentration, producing a high carrier mobility of 1467.7 cm2 V–1 s–1 for the Pb0.995Zn0.02Te sample. A high power factor of 4.11 mW m–1 K–2 is achieved for the Pb0.995Zn0.02Te sample at 306 K. This work provides new insights into understanding the nature and evolution of the defects in n-type PbTe as well as improving the electronic and thermal transport properties toward higher thermoelectric performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c14518.Experimental section, backscattering electron images, wavelength dispersive spectrometer results, electrical and thermal transport performance of the Pb1–yZnyTe samples, and room-temperature carrier mobility as a function of carrier concentration for the Pb1–yZn0.015+yTe samples and several n-type PbTe compounds (PDF)This article has not yet been cited by other publications.

Extraordinary role of Zn in enhancing thermoelectric performance of Ga-doped n-type PbTe

Modulating the Valence of Ga and the Deep Level Impurity for High Thermoelectric Performance of N-Type Pb0.98Ga0.02Te1-xSex Compounds

Enhanced thermoelectric performance of n-type Nb-doped PbTe by compensating resonant level and inducing atomic disorder

Valence Band Modification and Enhanced Phonon‐Phonon Interactions for High Thermoelectric Performance in GeTe

Achieving High-Performance N-Type PbTe Via Synergistically Optimizing Effective Mass and Carrier Concentration and Suppressing Lattice Thermal Conductivity

Promoted Na Solubility and Modified Band Structure for Achieving Exceptional Average ZT by Extra Mn Doping in PbTe.

Zn-Induced Defect Complexity for the High Thermoelectric Performance of n-Type PbTe Compounds

Enhanced Thermoelectric Performance of N-Type PbTe Through the Introduction of Low-Dimensional C60 Nanodots

GaSb Doping Facilitates Conduction Band Convergence and Improves Thermoelectric Performance in N-Type PbS

Enhanced thermoelectric performance of PbTe based materials by Bi doping and introducing MgO nanoparticles

Realizing High Thermoelectric Performance in the ZnTe-Alloyed CuGaTe 2 through Band Engineering

Enhanced Thermoelectric Performance of N‐Type PbSe Through Semi‐Coherent Nanostructure by AgCuTe Alloying

Thermoelectric figure of merit in Ga-doped [0001] ZnO nanowires

Synergistically optimizing carrier and phonon transport properties in n-type PbTe through I doping and SnSe alloying

Band and microstructure engineering toward high thermoelectric performance in SnTe

Achieving higher thermoelectric performance of n-type PbTe by adjusting band structure and enhanced phonons scattering

Contrasting Thermoelectric Transport Properties of n-Type PbS Induced by Adding Ni and Zn

Realizing n-type gete through suppressing the formation of cation vacancies and bi-doping*

Engineering atomic-level crystal lattice and electronic band structure for extraordinarily high average thermoelectric figure of merit in n-type PbSe

Synergistic optimization of electrical and thermal transport in n-type Bi-doped PbTe by introducing coherent nanophase Cu1.75Te

Achieving High Thermoelectric Performance in ZnSe-Doped CuGaTe2 by Optimizing the Carrier Concentration and Reducing Thermal Conductivity