Abstract:This paper presents the results of physical modelling of the process of multi-pass rolling of a wire rod with controlled, multi-stage cooling. The main goal of this study was to verify the possibility of using a torsion plastometer, which allows conducting tests on multi-sequence torsion, tensile, compression and in the so-called complex strain state to physically replicate the actual technological process. The advantage of the research methodology proposed in this paper in relation to work published so far, is its ability to replicate the entire deformation cycle while precisely preserving the temperature of the deformed material during individual stages of the reproduced technological process and its ability to quickly and accurately determine selected mechanical properties during a static tensile test. Changes in the most important parameters of the process (strain, strain rate, temperature, and yield stress) were analyzed for each variant. After physical modelling, the material was subjected to metallographic and hardness tests. Then, on the basis of mathematical models and using measurements of the average grain size, chemical composition, and hardness, the yield strength, ultimate tensile strength, and plasticity reserve were determined. The scope of the tests also included determining selected mechanical properties during a static tensile test. The obtained results were verified by comparing to results obtained under industrial conditions. The best variant was a variant consisting of physically replicating the rolling process in a bar rolling mill as multi-sequence non-free torsion; the rolling process in an NTM block (no twist mill) as non-free continuous torsion, with the total strain equal to the actual strain occurring at this stage of the technological process; and the rolling process in an RSM block (reducing and sizing mill) as tension, while maintaining the total strain value in this block. The differences between the most important mechanical parameters determined during a static tensile test of a wire rod under industrial conditions and the material after physical modelling were 1.5% for yield strength, approximately 6.1% for ultimate tensile strength, and approximately 4.1% for the relative reduction of the area in the fracture and plasticity reserve.

Experimental and numerical investigations of wire bending by linear winding of rectangular tooth coils

Characterization of Rectangular Copper Wire Forming Properties and Derivation of Control Concepts for the Kinematic Bending of Hairpin Coils

Manufacturing Techniques for Electric Motor Coils With Round Copper Wires

Investigation on the Torsional–Flexural Instability Phenomena during the Bending Process of Hairpin Windings: Experimental Tests and FE Model Validation

A Theoretical Study on Nonlinear Bending of Wires

Tension relaxation during the NOL ring winding process based on a novel tracking element method

A STUDY ON THE STRESS DISTRIBUTION IN COIL WRAPPING AND ITS EFFECT ON FINAL COIL DEFORMATION

Numerical Study on Mechanical Properties of Conductors on Round Core Cables

Mechanical Stress in Superconducting Coils During Winding Process

Validation of Bending Simulation Models Based on Yield Strength Influences of Electrical Steel Sheets on Stator Core Radius

Wire twisting stiffness modelling with application in wire race ball bearings. Derivation of analytical formula and Finite Element validation

Fundamental Investigations to Evaluate the Influence of Notching Processes on a Subsequent Cyclic Bending Process for the Production of Wire Cores

Characterization and computational modeling of electrical wires and wire bundles subject to bending loads

Investigation of the Mechanics of Wire Drawing

Computer Numerical Controlled Coil Winding of the Electric Welding Machine

Numerical and Experimental Investigation of Trapezoidal Wire Cold Drawing Through a Series of Shaped Dies

Investigation on Winding Theory for Short Primary Linear Machines

Innovative Methodology for Physical Modelling of Multi-Pass Wire Rod Rolling with the Use of a Variable Strain Scheme

STUDY ON THE COMPOSITE WINDING MECHANICAL PROPERTIES BY EXPERIMENT AND NUMERICAL SIMULATION

Study on Numerical Simulation for Control of Winding Process of Thin Wall Spiral Tube