Abstract:In this paper, 2 atom % Al-doped ZnO (AZO) was prepared by the co-precipitation method together with sparking plasma sintering (SPS) treatment. The as-synthesized AZO powders show the morphology of hollow hexagonal towers, which result in a high porosity of 50.6% in the bulk sample consolidated by SPS sintering at 400 °C, and the porosity decreases gradually with increasing sintering temperature up to 1000 °C. Positron annihilation measurements reveal that even after sintering at 1000 °C, there are still a considerable number of small pores. A high electrical conductivity of 3 × 105 S m–1 is achieved at room temperature for the AZO sample sintered at 1000 °C, while the absolute values of Seebeck coefficient keep at relatively high values between 59 and 144 μV K–1 in the measurement temperature range of 27–500 °C, leading to a high power factor of 3.4 × 10–3 W m–1 K–2. On the other hand, the pores in AZO act as strong phonon scattering centers, and an extremely low thermal conductivity of 1.5 W m–1 K–1 measured at room temperature is obtained for AZO sintered at 400 °C. Due to the residual pores in the 1000 °C-sintered sample, the thermal conductivity is still relatively low. As a result, a maximum ZT of 0.275 measured at 500 °C is obtained in this sample, which is the highest ZT reported for ZnO around this temperature.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c16506?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c16506</a>.Thermal gravity analysis for the Al-doped ZnO (Figure S1), TEM images of Al-doped ZnO sintered at different temperatures (Figure S2), and structural characterization and thermoelectric properties of undoped ZnO prepared by co-precipitation combined with SPS treatment (Figures S3–S5) (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c16506/suppl_file/am0c16506_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

The influence mechanism of donor doping from alkaline earth element on the thermoelectric properties of ZnO semiconductor materials for electricity meter

Study on the physical mechanism of thermoelectric transport on the properties of ZnO ceramics

Thermoelectric Properties and Electronic Structure of Al-Doped Zno

Enhanced thermoelectric properties of ZnO: C doping and band gap tuning

The influence mechanism of high-valence rare earth element doping on the thermoelectric properties of ZnO

Study on the mechanism of influence of impurity levels introduced by doping high-valence element on the properties of zinc oxide thermoelectric materials

Improvement mechanism of thermoelectric properties of ZnO ceramics by energy band regulation

Mechanism of Thermoelectric Performance Enhancement in CaMg2 Bi2 -Based Materials with Different Cation Site Doping.

Tuning the Thermoelectric Properties of Ca9zn4+Xsb9 by Controlled Doping on the Interstitial Structure

Regulating thermoelectric properties of Eu0.5Ca0.5Zn2Sb2 through Mg dopant

Molybdenum-doped zinc oxide: enhanced thermoelectric performances and unprecedented mechanical strengthening used for smart meters

Mechanism of Thermoelectric Performance Enhancement in CaMg2Bi2‐Based Materials with Different Cation Site Doping

Optimization of the thermoelectric performance of α-MgAgSb-based materials by Zn-doping

Enhancing the Thermoelectric Performance of Mgagsb-Based Materials with Heavy Zn-Doped

Enhanced Thermoelectric Properties of P-Type CaMg2Bi2 Via a Synergistic Effect Originated from Zn and Alkali-Metal Co-doping.

Microstructure and thermoelectric properties of Al-doped ZnO ceramic prepared by spark plasma sintering

Influence of Ce Doping on the Microstructure and High-temperature Electrical Property of CaMnO3 Ceramics

The Influence of Doping Sites on Achieving Higher Thermoelectric Performance for Nanostructured Α-Mgagsb

Significant Enhancement in the Thermoelectric Performance of Aluminum-Doped ZnO Tuned by Pore Structure

Realizing high thermoelectric performance in p-type CaZn2Sb2-alloyed Mg3Sb2-based materials via band and point defect engineering

The influence of ZrO2 doping on microstructure and electrical properties of ZnO-based conductive ceramics