Abstract:Soldering stacks of high temperature superconducting (HTS) tapes results in a current carrying matrix with high electrical, thermal, and mechanical stability. In some applications, these tape stacks may be exposed to elevated temperatures during thermal heat cycles. Previous research on thermal degradation of high temperature superconductors has been performed with isolated crystals or individual HTS tapes, showing that oxygen-out diffusion from the rare-earth barium copper oxide (REBCO) results in a reduction of the superconducting performance. In this work, the performance of Pb37Sn63 soldered HTS tape stacks with thermal cycling to 170C is quantified through determination of the critical current Ic, the n-value, the linear resistance R in the pre-transition region of the tape stack current-voltage (I-V) traces, and the diffusion coefficient D associated with oxygen-out diffusion. The effect of tape manufacturer and nickel electroplating were considered; three soldered stacks each of unplated Faraday, nickel electroplated Faraday, unplated SuperPower, and nickel electroplated SuperPower tapes were fabricated. Across 20 - 30 one hour thermal cycles, there is no strong correlation observed between the unplated or nickel electroplated tapes. There is however a marked difference in degradation profiles observed between the SuperPower and Faraday tape stacks. For the unplated and plated SuperPower tape stacks, the degradation in Ic generally follows the model to describe oxygen-out diffusion from the superconducting REBCO layer. Significantly less degradation is observed in the unplated and plated Faraday tape stacks, and in some sections Ic even increases slightly across cycles. Further, cases of increasing Ic accompanied with decreasing n are observed, a decoupling between the two parameters. Across all samples, the linear resistance was highest in current-redistribution regions near the leads. Consistent with the model of oxygen-out diffusion and the formation of an increasingly wide oxygen deficient layer in the REBCO, the linear resistance increased with cycle number.

Spatial modulation of Joule losses to increase the normal zone propagation velocity in (RE)BaCuO tapes

Manufacturing the current flow diverter architecture in REBCO tapes using silver inkjet printing

Enhanced Normal Zone Propagation Velocity in REBCO Coated Conductors Using an Intermetallic Stabilizer Coating

Growth of (Cu,C)Ba$_{2}$Ca$_{2}$Cu$_3$O$_{9+δ}$ thin films on flexible Hastelloy tapes

Synergic realization of electrical insulation and mechanical strength in liquid nitrogen for high-temperature superconducting tapes with ultra-thin acrylic resin coating

Growth of (cu,c)ba_2ca_2cu_3o_9+δ Thin Films on Flexible Hastelloy Tapes

Artificial Multilayers of REBaCuO/YBaCuO and YBCO/CuO(Y2O3) for High-Performance Long Tapes of Coated Conductors Derived by Metal Organic Solution Deposition

High-performance Ba1-xKxFe2As2 superconducting tapes with grain texture engineered via a scalable and cost-effective fabrication

The experimental research and analysis on the quench propagation of YBCO coated conductor and coil

Bending-Peeling Method to Research the Effect of Lateral Stress on Superconductivity of REBCO Tape at Liquid-Nitrogen Temperature

Advance in Long-Length REBCO Coated Conductors Prepared by Reel-to-Reel Metalorganic Solution and Ion-Beam-Assisted Deposition

Reduction Of Ac Transport And Magnetization Loss Of A High-T-C Superconducting Tape By Placing Soft Ferromagnetic Materials At The Edges

Performance degradation due to thermal cycling in soldered Faraday and SuperPower HTS tape stacks

Effect of combining a DC bias current with an AC transport current on AC losses in a High Temperature Superconductor

Enhanced mechanical strength and texture of (Ba,K)Fe 2 As 2 Cu/Ag composite sheathed tapes with Nb barrier layer

Rapid Doubling of the Critical Current of YBa$_2$Cu$_3$O$_{7-δ}$ Coated Conductors for Viable High-Speed Industrial Processing

Low field anomaly in the critical current of Ba1‐xKxFe2As2 tapes

Simulation and Visualization Experiment on the Liquid Nitrogen Boiling Behaviors During the Quenching and Recovery Process of YBCO Tapes

Progress in fabrication of second generation high temperature superconducting tape at Shanghai Superconductor Technology

Metastable structures with composition fluctuation in cuprate superconducting films grown by transient liquid-phase assisted ultra-fast heteroepitaxy

Optimization of REBCO Tapes through Division and Striation for Use in Superconducting Cables with Low AC Losses