Abstract:The purpose of this study is investigation of electrocoagulation (EC) as a treatment of municipal wastewater, integrating life cycle impact assessment (LCIA) for assessing its environmental performance of investigated treatment. The study evaluated the effectiveness of EC in removing physico-chemical and microbial parameters using aluminum (Al) and iron (Fe) electrodes in monopolar and bipolar modes. Bipolar arrangement of Al(−)/Al/Al/Al(+) electrodes achieved the highest removals: 70% COD, 72% BOD 5 followed by complete elimination of total phosphorous, turbidity and microbial parameters. This treatment was subject to investigation of the influence of reaction time (t = 10–60 min) on removals at higher current density (CD = 3.33 mA/cm 2 ). In order to reduce energy consumption, the same reaction time range was used with a reduced CD = 2.33 mA/cm 2 . Following removal efficiencies obtained: 47–72% COD (higher CD) and 53–78% (lower CD); 69–75% BOD 5 (higher CD) and 55–74% CD (lower CD); 12–21% NH 4 − (higher CD) and 7–22% NH 4 − (lower CD). Total P, NO 3 − and NO 2 − compounds showed the same removals regardless the CD. Decrease in current density did not influence removals of total suspended matter, turbidity, salinity as well as microbial parameters. The bipolar arrangement of Al(−)/Al/Al/Al(+) electrodes, assuming a lower CD = 2.33 mA/cm 2 and t = 30 min, was assessed with the Recipe 2016Midpoint (H) and USEtox v.2 LCIA methods to explore the environmental justification of using EC for wastewater treatment. The LCIA results revealed that the EC process significantly reduces water eutrophication and toxicity for freshwater and marine ecosystems, but has higher impacts in global warming, fossil fuel consumption, human toxicity, acidification, and terrestrial ecotoxicity due to high energy consumption. This can be mainly explained by the assumption in the study that the EC precipitate is dispersed to agricultural soil without any pre-treatment and material recovery, along with relatively high energy consumption during the process.

Electrocoagulation in treatment of municipal wastewater– life cycle impact assessment

Electrocoagulation removal of Pb, Cd, and Cu ions from wastewater using a new configuration of electrodes

Evaluation of scrap metallic waste electrode materials for the application in electrocoagulation treatment of wastewater

Development of electrocoagulation process for wastewater treatment: optimization by response surface methodology

Treatment of contaminated river water by batch electrocoagulation system using aluminium and iron electrodes: Performance of process and statistical analysis

Integrating of electrocoagulation process with submerged membrane bioreactor for wastewater treatment under low voltage gradients

Reduction of nutrients, microbes, and personal care products in domestic wastewater by a benchtop electrocoagulation unit

Investigation on operating parameters and cost using an electrocoagulation process for wastewater treatment

Domestic greywater treatment using electrocoagulation-electrooxidation process: optimisation and experimental approaches

Implications of advanced wastewater treatment: Electrocoagulation and electroflocculation of effluent discharged from a wastewater treatment plant

Techno-economic evaluation of electrocoagulation for cattle slaughterhouse wastewater treatment using aluminum electrodes in batch and continuous experiment

CHEMICAL COAGULATION AND ELECTROCOAGULATION IN TREATMENT TECHNOLOGY FOR ENVIRONMENTAL GREEN COMMUNITY

Pollutant Removal Efficiency of Electrocoagulation Method from Industrial Wastewater: Comparison with Other Treatment Methods and Key Operational Parameters—a Comparative Study Review

Hospital wastewater treatment using electrocoagulation: Performance, kinetics, settlement analysis, and cost-effectiveness

Combined Coagulation-Electrocoagulation Treatment of Urban, Peri-urban, and Textile Wastewaters: Process Evaluation and Sludge Setting Characteristics

Performance and Mechanistic Study on Electrocoagulation Process for Municipal Wastewater Treatment Based on Horizontal Bipolar Electrodes

Impact of Combined Electrolysis and Activated Sludge Process on Municipal Wastewater Treatment

Removal of nutrients and other emerging inorganic contaminants from water and wastewater by electrocoagulation process

Optimization of the electrocoagulation process for the removal of lead from water using aluminium as electrode material

An economical electrocoagulation process of a hazardous anionic azo dye wastewater with the combination of recycled electrodes and solar energy

Treatment of highly concentrated tannery wastewater using electrocoagulation: Influence of the quality of aluminium used for the electrode