Abstract:Hybrid treatment technology in recent time is seen as novel treatment technology for treatment of various types of wastewaters. Over the past few decades, electrochemical treatment coupled with adsorption for wastewater treatment has gained much attention. Raw hospital wastewater (HWW) was treated coupling continuous flow electrochemical coagulation (ECC) and adsorption for removal of pollutants/contaminants chemical oxygen demand (COD), colour, and total dissolved solids (TDS). The electrochemical treatments in continuous mode were carried out for applied voltage of 12 and 18 V using Al and SS electrodes for flow rates 6 Lph, 4 Lph, 2 Lph, and 1 Lph coupled with adsorption. COD removal of 79.4% and 75.26% were obtained at 90 min ET for 12 and 18 V using Al electrodes with corresponding colour removal of 77.15% and 74.49% and TDS residual concentration of 452 mg/L (12 V) (45.14% removal) and 431 mg/L (18 V) (47.69% removal) from its initial concentration C o of 824 mg/L respectively. Similarly, continuous ECC studies using SS electrodes showed maximum COD removal of 75.26% and 73.85 for 12 and 18 V at 90 min ET for flow rate 1 Lph. Colour removal of 77.15% and 74.46% was observed at the end of 330 min ET with simultaneous TDS concentration reduction of 423 mg/L (48.66% removal) and 408 mg/L (50.48% removal) respectively. The initial COD and colour concentration before ECC were 768 mg/L and 0.404 (absorbance). The breakthrough capacity for Al electrodes was comparable with SS electrodes ranging from 73 to 107.78 g/L. Adsorption kinetics showed that the Adam Bhorat model constants increased with increase in flow rates with pollutant removal controlled by external mass transfer. The ECC + adsorption coupled hybrid treatment process showed disinfection potential by destruction of the microbial mass by both Al and SS electrodes. At the end of the electrochemical treatment, the agar plate count was < 10 CFU/mL for Al and < 5 CFU/mL for SS electrodes. The operating cost of the hybrid process is 41.65 and 50.95 INR/m 3 of HWW treated for the desired 75–80% COD removal using Al and SS electrodes. The ECC coupled adsorption process showed its effectiveness and may be successfully applied for the treatment.

CHEMICAL COAGULATION AND ELECTROCOAGULATION IN TREATMENT TECHNOLOGY FOR ENVIRONMENTAL GREEN COMMUNITY

A Combined Electrocoagulation-Electrooxidation Treatment on Ctmp Wastewater

Implications of advanced wastewater treatment: Electrocoagulation and electroflocculation of effluent discharged from a wastewater treatment plant

Combined Coagulation-Electrocoagulation Treatment of Urban, Peri-urban, and Textile Wastewaters: Process Evaluation and Sludge Setting Characteristics

Development of electrocoagulation process for wastewater treatment: optimization by response surface methodology

Electrocoagulation In Water Treatment

Treatment of contaminated river water by batch electrocoagulation system using aluminium and iron electrodes: Performance of process and statistical analysis

Investigation on operating parameters and cost using an electrocoagulation process for wastewater treatment

A review of electrocoagulation as a promising coagulation process for improved organic and inorganic matters removal by electrophoresis and electroflotation

Techno-economic evaluation of electrocoagulation for cattle slaughterhouse wastewater treatment using aluminum electrodes in batch and continuous experiment

A critical review of state-of-the-art electrocoagulation technique applied to COD-rich industrial wastewaters

Electrocoagulation in treatment of municipal wastewater– life cycle impact assessment

A review on electrocoagulation process for the removal of emerging contaminants: theory, fundamentals, and applications

Treatment of CNC industry wastewater by electrocoagulation technology: an application through response surface methodology

Effect of current density on COD removal efficiency for wastewater using the electrocoagulation process

Removal of nutrients and other emerging inorganic contaminants from water and wastewater by electrocoagulation process

Hospital wastewater treatment using electrocoagulation: Performance, kinetics, settlement analysis, and cost-effectiveness

Integrating of electrocoagulation process with submerged membrane bioreactor for wastewater treatment under low voltage gradients

Electrocoagulation-based wastewater treatment process and significance of anode materials for the overall improvement of the process: A critical review

Electrocoagulation removal of Pb, Cd, and Cu ions from wastewater using a new configuration of electrodes

Hybrid Treatment of Hospital Wastewater Combining Continuous Flow Electrochemical Coagulation Coupled with Adsorption