Abstract:Background and objective: In vitro studies were conducted to evaluate the use of an automated system for high-speed scanning of single 9.3 µm CO2 laser pulses in the inhibition of caries-like lesion formation in the enamel of extracted human molars. The effect of the laser in generating an acid-resistant layer and the effect of the layer on inhibiting surface mineral loss during pH cycling was explored. Study design/materials and methods: Laser irradiation was performed with fluences of 0.6, 0.8, and 1.0 J/cm2 for single pulses of 1 mm diameter (1/e2 ), with pulse durations of 17, 22, and 27 microseconds, respectively. The laser was scanned at a 750 Hz pulse repetition rate in an automated pattern covering an area of 7 mm2 in 0.3 sec. Six treatment groups were investigated: three groups for each fluence for laser-only and three for laser irradiation with additional fluoride from a toothpaste slurry (sodium fluoride at 1100 ppm). Each group used non-irradiated areas, which included untreated controls for the laser-only groups and a fluoride-only treatment for the groups with additional fluoride. pH cycling was performed on both groups, followed by microhardness testing to determine the relative mineral loss (∆Z) from a caries-like formation and surface mineral loss (∆S). Results: Laser irradiation with the 9.3 µm CO2 laser generated an acid-resistant layer of about 15 µm in depth. For the laser-irradiated samples with additional fluoride application, the relative mineral loss (∆Z) was 113 ± 63 vol%-µm, while for those with only fluoride application ∆Z was 572 ± 172 vol%-µm. At the highest fluence (1.0 J/cm2 ) used, an 80.2% inhibition of caries-like lesion was measured by ∆Z. Using only laser irradiation at the highest fluence resulted in an inhibition of caries-like lesion of 79.5% for the irradiated samples (∆Z = 374 ± 149 vol%-µm) relative to the control (∆Z = 1826 ± 325 vol%-µm). Surface microhardness tests resulted in an inhibition of surface softening, as measured by the Knoop Hardness Value (KHN) (108 ± 33 KHN for laser irradiated with additional fluoride, for non-irradiated controls with fluoride only 52 ± 16 KHN). Inhibition of surface loss was observed for all laser fluences, but the maximum surface loss for the untreated control group was only 2.2 ± 0.49 µm. Conclusions: The results demonstrate a significant benefit of the 9.3 µm CO2 laser at fluences of 0.6, 0.8, and 1.0 J/cm2 in caries-like lesion inhibition as measured by the relative mineral loss in depth and surface mineral loss, without significant damage to the enamel. Additionally, inhibition of surface softening and surface loss during pH cycling was observed. The surface loss was small compared with the overall lesion depth and thickness of the generated acid-resistant layer. Lasers Surg. Med. © 2020 Wiley Periodicals LLC.

Acquired acid resistance of enamel and dentin by CO2 laser irradiation with sodium fluoride solution.

CO2 laser inhibitor of artificial caries-like lesion progression in dental enamel

Effect of Laser Irradiance and Fluoride Varnish on Demineralization Around Dental Composite Restorations

Demineralization Inhibition by High-Speed Scanning of 9.3 µm CO2 Single Laser Pulses Over Enamel

THE EFFECT OF COMBINED TREATMENT BY LASER AND FLUORIDE ON THE ACID RESISTANCE OF ENAMEL IN PRIMARY TEETH (IN-VITRO STUDY)

In vitro controlled elemental analysis to evaluate the combined effect of acidulated phosphate fluoride with Er:YAG and diode lasers

Clinical and ex-vivo effect of LASERs on prevention of early-enamel caries: systematic review & meta-analyses

In-air micro-proton-induced X-ray/gamma-ray emission analysis of the acid resistance of root dentin after applying fluoride-containing materials incorporating calcium

The Combination of Laser and Nanoparticles for Enamel Protection: An In Vitro Study

Prevention of dentine caries using silver diamine fluoride application followed by Er:YAG laser irradiation: an in vitro study

The acid resistance, roughness, and microhardness of deciduous enamel induced by Er:YAG laser, fluoride, and combined treatment: an in vitro study

An SEM study on the effect of 9.3-µm CO2 laser on dentinal tubules for hypersensitivity treatment

Low-level gallium-aluminum-arsenide (GaAlAs) diode laser irradiation (λ 830 nm) associated with and without fluoridated gel in the prevention of enamel erosion

Effect of silver diamine fluoride and ammonium hexafluorosilicate applications with and without Er:YAG laser irradiation on the microtensile bond strength in sound and caries-affected dentin

Effect of combining aminomethacrylate and fluoride against erosive and abrasive challenges on enamel and dentin

Dentinal Tubule Occluding Efficacy Of Er: YAG Laser And Universal Adhesive Loaded With Nano-Carbonated Apatite

Comparative study of the effect of laser irradiation and acid etching surface treatment on bonding of some dental restorative materials To dentin surface

A comparison of conventional sodium fluoride varnish and nano-sodium fluoride varnish regarding enamel microhardness of deciduous teeth: an in-vitro study

Preventive effect of experimental polymer-based desensitizers with NaF on demineralization of root dentin -observed using micro-CT

Effect of fluoride-treated enamel on indirect cytotoxicity of a 16% carbamide peroxide bleaching gel to pulp cells

Effect of Er:YAG Laser Irradiation on Preventing Enamel Caries: A Systematic Review and Meta-Analysis