Abstract:Thermal insulation materials are widely used in the fields of thermal protection and the energy conservation at high temperature. Thermal conductivity is one of the most important parameters of characterizing the thermal insulation performance of thermal protection materials. Steady state method such as the guarded hot plate method is normally considered as the most accurate method to measure the thermal conductivity of thermal insulation materials, but the temperature range is limited to below 1000 K. Unsteady state method can be employed at higher temperature but the accuracy is lacking of validation. Consequently, thermal verification experiments are usually conducted by heating the front surface of thermal insulation materials to a very high temperature. However, it is difficult to obtain the temperature-dependent thermal conductivity by using the thermal insulation performance measured with a large temperature difference across the material. In this study, a sandwich structure experimental system is built to carry out the thermal insulation performance tests with a large temperature difference at both steady state and transient state. Both uniform temperature layer method and polynomial fitting method are adopted to extract the temperature-dependent thermal conductivity from the large temperature difference test at steady state. A new transient state identification method is proposed based on the niche genetic algorithm to identify the relation between thermal conductivity and temperature from the transient thermal response. The temperature-dependent thermal conductivity of four thermal protection materials are finally obtained. The identification results prove that the proposed transient identification method is reliable and robust.

Identifiability of Electrical and Heat Transfer Parameters Using Coupled Boundary Measurements

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Identification of Thermodiffusion Coefficients in an Aqueous Potassium Ferri/ferrocyanide Thermocell Using Open-Circuit Voltage Data

Characterization Of Near-Field Coupling Effects From Complicated Three-Dimensional Structures In Rectangular Cavities Using Fast Integral Equation Method

Thermal-aware electrical analysis of high-speed interconnect

Emission and Susceptibility Modeling of Finite-Size Power-Ground Planes Using a Hybrid Integral Equation Method

A Coupled Complex Boundary Method for Parameter Identification in Elliptic Problems.

Experimental Identification of Thermophysical Properties in Heterogeneous Materials with Integral Transformation of Temperature Measurements from Infrared Thermography

A Coupled Complex Boundary Method for an Inverse Conductivity Problem with One Measurement

Parameter identification for coupled finite element–boundary element models

The Reconstruction of the Space-Dependent Thermal Conductivity from Sparse Temperature Measurements

The Boundary Induced Error on the Measurement of Thermal-Conductivity by Transient Hot-Wire Method

Simultaneous measurements of high-temperature total hemispherical emissivity and thermal conductivity using a steady-state calorimetric technique

Temporal coupled mode theory linking to surface-wave dispersion relations in near-field electromagnetic heat transfer

Identification of Pipe Inner Surface in Heat Conduction Problems by Deep Learning and Effective Thermal Conductivity Transform

APPLICATION OF HYBRID LAPLACE TRANSFORM/ FINITE-DIFFERENCE METHOD TO TRANSIENT HEAT CONDUCTION PROBLEMS

Estimation of the Heat Conducted by a Cluster of Small Cavities and Characterization of the Equivalent Heat Conduction

Integral identification of fluid specific heat capacity and heat transfer coefficient distribution in heat exchangers based on multiple-case joint analysis

A new approach for the estimation of temperature-dependent thermal properties by solving transient inverse heat conduction problems

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

Determination of the Thermal Conductivity and Volumetric Heat Capacity of Substance from Heat Flux