Abstract:This work focuses on continuously operated spray granulation processes in horizontal fluidized beds highlighting the influence of process conditions on the particle properties of the resulting product granules. The drying process has a decisive influence on the kinetics of the growth rate and thus also on the properties of the particles, such as the morphological structure, particle moisture content and porosity as well as density, compression strength and the wetting behavior. This influence has been considered in this study in more detail on the basis of the model material sodium benzoate. In order to compare the produced granules at different drying conditions and spray rates of the suspension an external product classification was used to achieve a certain product granule size. The obtained experimental results show a deep influence of the thermal conditions onto granule morphology and structural properties, which is in qualitative agreement with recent experimental observations (Rieck et al., 2015; Hoffmann et al., 2015a; Schmidt et al., 2017b). The overall trend of the results reveal smoother product granules with decreasing spray rates of the suspension and increasing drying temperatures. These smoother surface morphologies lead to a more homogeneous layering which has as a consequence that the internal particle porosity is decreasing while the solids density and the compression strength of the particles are increasing at the same time. In this study the purely qualitative classification of the surface texture from previous experimental studies was extended by the topographic analysis of the product granules, giving the possibility to quantify the morphological structure by means of roughness measurements. This makes the morphological design accessible as product property and permits the utilization of models that describe the morphology according to the process conditions.

Impact of the drying rate on product properties of spray dried emulsions to enable a targeted product design

Effect of droplet collisions on evaporation in spray-drying

Modelling the primary drying stage of the spray freeze drying process based on the non-equilibrium formulation

A new method for continuous measurement of residence time distribution in spray drying

Effect of the condition of spray-drying on the properties of the polypeptide-rich powders from enzyme-assisted aqueous extraction processing

Influence of drying conditions on layer porosity in fluidized bed spray granulation

Spray drying encapsulation of essential oils: Insights on various factors affecting the physicochemical properties of the microcapsules

Particle morphology and shrinkage in spray dryers: A review focused on modeling single droplet drying

Effect of the Addition of Diblock Copolymer Nanoparticles on the Evaporation Kinetics and Final Particle Morphology for Drying Aqueous Aerosol Droplets

Influence of process conditions on the product properties in a continuous fluidized bed spray granulation process

Effects of different mesh nebulizer sources on the dispersion of powder formulations produced with a new small-particle spray dryer

Experimental Investigation of Spray Drying Breakup Regimes of a PVP-VA 64 Solution Using High-Speed Imaging

Analysis of product properties in counter-current spray drying with two nozzles system

Describing the Drying and Solidification Behavior of Single Suspension Droplets Using a Novel Unresolved CFD-DEM Simulation Approach

Effect of Physical Properties of an Emulsion Pesticide on the Atomisation Process and the Spatial Distribution of Droplet Size

Development of In-Line Measurement Techniques for Monitoring Powder Characteristics in a Multi-Stage Spray Drying Process

Influence of drying conditions on the stress and weight development of capillary suspensions

Microencapsulation of Flaxseed Oil by Spray Drying: Effect of Oil Load and Type of Wall Material

Mechanistic Formulation Design of Spray-Dried Powders

Spray drying encapsulation of essential oils; process efficiency, formulation strategies, and applications

Ultrasonic spray freeze-drying of sucrose and mannitol-based formulations: Impact of the atomization conditions on the particle morphology and drying performance