Abstract:Material microstructures often contain non-uniformly distributed features of complex geometry. Attributes of three-dimensional microstructural geometry have dominant influence on the mechanical behavior of materials. Therefore, it is of interest to incorporate quantitative description of actual three-dimensional microstructures in micromechanical analysis of materials. In this contribution, a methodology has been developed to perform finite element (FE)-based simulations on complex three-dimensional microstructures, through its application to cast microstructure of A356 Al-alloy containing non-uniformly distributed pores of complex geometry. As expected, the simulations reveal that the distributions of local stresses and strains depend on size, orientation, and spatial arrangement of the pores in a complex manner. FE-simulations on the three-dimensional pore structure have been used to simulate the growth of the voids by the McClintock rule. These simulations clearly demonstrate that unit cell model can be used in the study the void growth behavior of materials at the stress levels close to global yield stress, and it overestimates the void growth at the stress levels significantly higher global yield stress. The FE-simulations reveal a general trend that larger voids have a higher percentage increase in their volume. Therefore, at a given applied stress level, absolute rate of volume change of a pore increases with its initial pore volume in a non-linear manner. These observations are supported by experimental measurements of pore growth. It is shown that micromechanical response does not vary significantly if the pores are replaced by equivalent ellipsoids, and such a model can be used to simulate the growth of non-uniformly distributed voids of complex geometry at all stress levels.

Integrating MIL and Mori–Tanaka methods for microstructural analysis and mechanical behaviour prediction in heterogeneous materials

Micromechanical Simulation on Strength and Ductility of Two Kinds of Al-based Nanostructural Materials

Prediction of Mechanical Properties in Bimodal Nanotwinned Metals with a Composite Structure

A micromechanical scheme with nonlinear concentration functions by physics-guided neural network

Cohesive Mohr–Coulomb interface effects on the strength criterion of materials with granular-based microstructure

A micromechanics-enhanced finite element formulation for modelling heterogeneous materials

A microstructure-guided constitutive modeling approach for random heterogeneous materials: Application to structural binders

Three dimensional modeling of complex heterogeneous materials via statistical microstructural descriptors

A statistical descriptor based volume-integral micromechanics model of heterogeneous material with arbitrary inclusion shape

Multiscale Approaches: From The Nanomechanics To The Micromechanics

Comparative Study of Two Multiscale Thermomechanical Models of Polycrystalline Shape Memory alloys: Application to a Representative volume Element of Titanium-Niobium

Micromechanics of complex three-dimensional microstructures

Multiscale Modelling of Mechanical Response in a Martensitic Steel: A Micromechanical and Length-Scale-dependent Framework for Precipitate Hardening

X-ray scattering tensor tomography based finite element modelling of heterogeneous materials

Influence of Material Inhomogeneity on the Mechanical Response of a Tempered Martensite Steel

Modelling the anisotropy evolution in sheet metals with heterogeneous properties

A novel microstructure-informed machine learning framework for mechanical property evaluation of SiC f /Ti composites

A Multiscale Mechanical Model for Materials Based on Virtual Internal Bond Theory

An Efficient Method for Multiscale Modelling of the Mechanical Properties of Additively Manufactured Parts with Site-specific Microstructures

Multiscale modeling of interface-mediated mechanical, thermal, and mass transport in heterogeneous materials: Perspectives and applications

Integrated Digital Image Correlation for Micro-Mechanical Parameter Identification in Multiscale Experiments