Abstract:We present a first of its kind framework which overcomes a major challenge in the design of digital systems that are resilient to reliability failures: achieve desired resilience targets at minimal costs (energy, power, execution time, area) by combining resilience techniques across various layers of the system stack (circuit, logic, architecture, software, algorithm). This is also referred to as cross-layer resilience. In this paper, we focus on radiation-induced soft errors in processor cores. We address both single-event upsets (SEUs) and single-event multiple upsets (SEMUs) in terrestrial environments. Our framework automatically and systematically explores the large space of comprehensive resilience techniques and their combinations across various layers of the system stack (586 cross-layer combinations in this paper), derives cost-effective solutions that achieve resilience targets at minimal costs, and provides guidelines for the design of new resilience techniques. We demonstrate the practicality and effectiveness of our framework using two diverse designs: a simple, in-order processor core and a complex, out-of-order processor core. Our results demonstrate that a carefully optimized combination of circuit-level hardening, logic-level parity checking, and micro-architectural recovery provides a highly cost-effective soft error resilience solution for general-purpose processor cores. For example, a 50x improvement in silent data corruption rate is achieved at only 2.1% energy cost for an out-of-order core (6.1% for an in-order core) with no speed impact. However, selective circuit-level hardening alone, guided by a thorough analysis of the effects of soft errors on application benchmarks, provides a cost-effective soft error resilience solution as well (with ~1% additional energy cost for a 50x improvement in silent data corruption rate).

In-Field Logic Repair of Deep Sub-Micron CMOS Processors

Eliminating Timing Errors Through Collaborative Design to Maximize the Throughput

A Kind of Low-cost Non-intrusive Autonomous Fault Emulation System

Fault-Tolerant Nanoscale Processors on Semiconductor Nanowire Grids.

A Fully Automated Large-Scale Addressable Test Chip Design with High Reliability

A Flexible Soft Error Mitigation Framework Leveraging Dynamic Partial Reconfiguration Technology

Design of Processor Based on Fault-tolerant Technology

An Energy-Efficient Microprocessor Using Multilevel Error Correction For Timing Error Tolerance

Combining Circuit Level and System Level Techniques for Defect-Tolerant Nanoscale Architectures

On Effective and Efficient In-Field TSV Repair for Stacked 3D ICs

CLEAR: Cross-Layer Exploration for Architecting Resilience - Combining Hardware and Software Techniques to Tolerate Soft Errors in Processor Cores

Tolerating Soft Errors in Processor Cores Using CLEAR (Cross-Layer Exploration for Architecting Resilience)

Non-interfering On-line and In-field SoC Testing

A Timing Failure Tolerance Design with In-Field Simultaneous Error Detection and Correction.

A Near Threshold Error Resilient Processor Based on Dynamic Timing Error Prediction and Within-a-cycle Timing Error Correction

Injecting Redundant Instructions Behind Branches for a Fault-Tolerant Architecture

Logic Diagnosis Based on Logic Built-In Self-Test Signatures Collected In-Field from Failing System-on-Chips

Logic-DRAM co-design to efficiently repair stacked DRAM with unused spares

Logic-DRAM Co-Design to Exploit the Efficient Repair Technique for Stacked DRAM

DuckCore: A Fault-Tolerant Processor Core Architecture Based on the RISC-V ISA

Techniques to Reduce the Soft Error Rate of a High-Performance Microprocessor