Abstract:The processes of impact loading have been studied for a long time, but there are still many questions, the solution of which is vital for various industries, especially for the military. This paper presents the results of comprehensive experimental studies to determine the energy characteristics of fracture during crack initiation and propagation in Charpy specimens of high-strength steel Hardox 450 and armored steel Armox 500T, cut from sheets in two different directions, during impact bending tests. The tests were carried out on an instrumented vertical tester equipped with a high-speed data recording system in the temperature range from –196 to 300 °C. According to the test results, the load diagrams in the force-time coordinates were obtained. The total deformation and fracture energy and its components, nucleation energy, ductile growth, brittle crack slip, and ductile fracture energy of the specimen were calculated. Using quantitative fractography methods, the specimens' fracture surfaces were studied, and the specific deformation and fracture energies and their components were determined. It is shown that the direction of cutting of specimens significantly affects the energy characteristics of fracture. On the upper shelf in the specimens cut in the longitudinal direction, the energy value is higher than for the transverse direction for both steels. This difference is approximately 38% for Hardox 450 and almost 118% for Armox 500T. Using a high-speed recording system allows us to determine the average crack propagation velocity and crack velocities in separate areas by comparing the corresponding zones on the load diagram and on the fracture surface of the specimens. The results showed that the average crack propagation velocity for specimens cut in the transverse direction was 10–15% higher than for specimens cut in the longitudinal direction for both steels.

Meso–Macro Energy Exchange in Shock-Wave Processes and Dynamic Strength of AB2 Steel

Adiabatic Shear Fractures and Fragments of Cylindrical Structures under Internal Explosive Loading

Dynamic deformation of Al under shock loading

Dynamic Fracture in Brittle Solids at High Rates of Loading

The effect of shock-wave profile on dynamic brittle failure

Fracture Energy Characteristics of High-Strength Steels Hardox 450 and Armox 500T Under Impact Bending

The Quasi-Coarse-Grained Dynamics Method to Unravel the Mesoscale Evolution of Defects/Damage during Shock Loading and Spall Failure of Polycrystalline Al Microstructures

Macroscopic Shock Plasticity of Brittle Material Through Designed Void Patterns

Structure–Phase Transformations and Properties of Non-Ferrous Metals and Alloys under Extreme Conditions

Dislocation evolution and peak spall strengths in single crystal and nanocrystalline Cu

The effect of crystal anisotropy and plastic response on the dynamic fracture of energetic materials

Synergistic Effect of Energy Absorption and Adiabatic Temperature on the Microstructural Evolution and Mechanical Properties During High-Speed Impacts

Shock Response and Evolution Mechanism of Brittle Material Containing Micro-Voids

Spallation fracture dependence on shock intensity and loading duration in single-crystal aluminum

Mesoscopic Picture of Fracture in Porous Brittle Material under Shock Wave Compression

Shock interactions with heterogeneous energetic materials

Dynamic Characterization of Shock Wave Responses of Bicontinuous Nanoporous Amorphous Alloys: Microstructure Effects

Effect of the Temperature of Shock-Wave Loading on Structure and Phase Transformations in Nitrogen-Containing Austenitic Cr–Mn–Ni Steel

Effect of Microstructure on High-Strength Low-Alloy Steel Welded Joint Toughness with Simulation of Heat-Affected Zone Coarse-Grained Area

Enhanced spall strength of single crystal aluminum by temperature rise mitigation and structural phase transition under shock pulse

Dynamic response and microstructure evolution of titanium alloy plates under low-velocity impact