Abstract:This article demonstrates a novel type of series‐fed planar antenna array for a W‐band (70 GHz) application. The proposed architecture is a 5‐element antenna array with 10 numbers of gap‐coupled parasitic patches in microstrip configuration over a thin, flexible and bio‐compatible substrate named LCP (liquid crystal polymer). The proto version of the antenna offers peak directive gain of about 19 dBi with better than 22 dB of return loss and 80% radiation efficiency for the frequency range of 67–85 GHz. Summary This article demonstrates a novel type of series‐fed planar antenna array for a W‐band (70 GHz) application. The proposed architecture is a 5‐element antenna array with 10 numbers of gap‐coupled parasitic patches in microstrip configuration over a thin, flexible and bio‐compatible substrate named LCP (liquid crystal polymer). A detailed design methodology with all fabrication constraints has been elaborated on here. Full wave analysis of the whole structure has been carried out in the FEM‐based 3D electromagnetic (EM) solver ANSYS HFSS Suite V.19.2. Parametric simulations were studied to achieve the optimized values of all design parameters. Further, an empirical electrical equivalent circuit model is proposed for the antenna array, and it was validated with the simulation results obtained from the FEM solver. Two prototypes have been fabricated, and measurements were carried out to fetch all the designed antenna parameters. The proto version of the antenna offers peak directive gain of about 19 dBi with better than 22 dB of return loss and 80% radiation efficiency for the frequency range of 67–85 GHz. Experimental and simulated results closely match each other. Small deviations are attributed to practical imperfections incurred by fabrication tolerances, measurement inaccuracies, testing, assembly‐related issues and so forth. Finally, the current research work is compared with the recently reported literature.

Inkjet‐printed capacitively loaded Marchand baluns with enhanced fractional bandwidths

Compact CMOS Baluns for the 4–10 GHz Band Applications

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

An Advanced Broadband Absorptive Balun for Modern Communication Systems

Notice of Retraction: A Novel Coplanar Common-Mode Filter with a Wide Stopband

A Printed Single-Layer UWB Monopole Antenna With Extended Ground Plane Stubs

Reproducible and highly miniaturized bazooka RF Balun using a printed capacitor

A Compact Metasurface-Enabled Dual-Band Dual-Circularly Polarized Antenna Loaded With Complementary Split Ring Resonators

A Wideband High-Isolated Dual-Polarized Patch Antenna Using Two Different Balun Feedings

800Mhz~2.5ghz Miniaturized Multi-layer Symmetrical Stacked Baluns for Silicon Based RF ICs

An Ultra Wideband Antenna Based on Tightly Coupled Effect with Practical Compact Balun

A Wideband Differential-Fed Slot Antenna Using Integrated Compact Balun with Matching Capability

Miniaturized Wideband Metasurface Antennas Using Cross-Layer Capacitive Loading

A Compact Dual-Decoupling Scheme for Aperture-Coupled and Probe-Fed Closely Spaced Wideband Microstrip Antennas

Planar Compact Dual-Band Balun with Flexible Frequency Ratios

Low-Sidelobe Air-Filled Slot Array Fabricated Using Silicon Micromachining Technology for Millimeter-Wave Application

Design of compact balanced filters with wide DM upper stopband and CM rejection band based on semi‐circular patch

A Broadband Monolithic Balun Based on 0.13μ CMOS m Process Using Planar-Spiral Transformers

A Broadband Monolithic Balun Based on 0.13/spl mu/m CMOS Process Using Planar-Spiral Transformers

High‐gain W‐band‐printed antenna on flexible substrate

A Broadband Balun With Tunable Phase-Shifting Function for Low-Cost Phased Array